SELECT CODE NUMBER
OF YOUR DBS RECEIVER
40
REFER TO
INSTRUCTION BOOK
SET: ,9
TEST: OK
END: MENU
Setting the Controller to Operate a DBS 53
• If you use a DBS, you must set the clock manually. Details are on
pages 14-15.
• Complete the steps on page 27 before proceeding. This will allow
you to use the VCR remote control to operate the DBS, and you
will learn your DBS code.
• The Controller can change channels
at the DBS only during a timer
recording.
Helpful Hint
1
Turn on the DBS. Select a
channel other than 205.
1
Turn on the DBS. Select a channel other than 205.
2
Press the VCR button, then press the MENU button.
3
Press the PLAY 8 or STOP 9 button to select INITIAL
SET UP, then press the OK/STATUS button.
4
Press the PLAY 8 or STOP 9 button to select DBS
RECEIVER, then press the OK/STATUS button.
5
Press the PLAY 8 or STOP 9 button to select the output
channel of your DBS receiver, then press the OK/STA-
TUS button. The display shown below will appear. If DBS
RECEIVER USERS SET CLOCK MANUALLY appears, follow steps
4-8 on page 15, then go to step 6 on page 54.
DBS RECEIVER CONTROLLER
OFF
A OFF CH. =CHANNEL
ON CH. 3
ON CH. 4
ON A/V FRONT
ON A/V REAR
SELECT: ,9 CONFIRM: OK
END: MENU
A VCR SET UP
TUNER SET UP
INITIAL SET UP
TAPE MANAGER
SELECT: 89 CONFIRM: OK
END: MENU
➔ CLOCK
LANGUAGE ENGLISH
VCR PLUS+ CH.
CABLE BOX
DBS RECEIVER
SELECT: 89 CONFIRM: OK
END: MENU
Instructions continue on page 54.
