807428
7
Zoom out
Zoom in
Previous page
1/12
Next page
Copyright © 2016 Peruzzo Italy - MADE IN ITALY7/12
660_FIRENZE_21/02/18
E GB D
MONTAJE DE LAS CORREAS F3
INFERIORES
1. Ensamble las correas F3 (inferiores) en el portabici-
cletas, tal como se muestra en el punto , pres-
tando atención al correcto paso de la correa por
el tensor R y al correcto sentido de entrada en la
hebilla, .
2. Verifique que las correas estén firmemente sujetas,
tirando de las mismas, .
3. Enganche las correas F3 en la parte inferior de la
puerta trasera, . Tire fuerte.
4. No apoye la parte inferior del portabicicletas
sobre las partes horizontales de la carrocería o
sobre el parachoques. Mantenga el portabicicle-
tas en suspensión según se explica en .
5. Tire con una fuerza de 2,5 Nm, .
6. Si el coche tiene gancho para remolque, sujete la
correa F3 derecha según se explica en .
ATENCIÓN
En algunos casos, la parte inferior de la puerta trasera
o de la tapa del maletero está desprovista de reborde
para fijar el gancho. En este caso, utilice el adaptador I (si
está incluido) y siga el esquema (si el adaptador I no
está incluido en el paquete del portabicicletas, puede
adquirirlo por separado en el punto de venta).
17
5
5
20 21 22
19
23
24
18
FITTING THE BOTTOM STRAPS F3
1. Assemble the straps F3 (bottom) on the bike carrier
as , taking care with the correct passage of the
strap on the tensioner R and the correct entrance
direction of the buckle, .
2. Check the hold of the straps by pulling on them, .
3. Couple the belts F3 at the bottom part of the rear
door, . Pull hard.
4. Do not place the bottom part of the bike carrier
on the horizontal parts of the bodywork or on
bumpers. Keep the bike carrier suspended as
shown in .
5. Pull with the application of a force of 2.5 Nm, .
6. If the car is equipped with a tow hook, fix the right
strap F3 as shown in .
ATTENTION
In some cases, the bottom part of the rear door/boot
has no edge for fixing the hook. In this case use the
adapter I , if included, and follow the diagram in (if
adapter I is not included in the package, you can pur-
chase one separately at the sales outlet).
17
5
5
20 21 22
19
23
24
18
ANBRINGEN DER UNTEREN RIEMEN F3
1. Die (unteren) Riemen F3 , wie in gezeigt, auf
den Fahrradträger montieren. Achten Sie darauf,
dass der Riemen korrekt durch den Spanner R
geführt wird und richtig herum in die Schnalle
eintritt, .
2. Durch kräftiges Ziehen an den Riemen prüfen, ob
sie festsitzen, .
3. Die Riemen F3 im unteren Teil der Heckklappe ein-
hängen, . Kräftig ziehen.
4. Das Unterteil des Fahrradträgers darf nicht auf
den horizontalen Teilen der Karosserie oder der
Stoßstange aufliegen. Der Fahrradträger muss
aufgehängt sein, wie in gezeigt.
5. Mit einer Kraft von 2,5 Nm anziehen, .
6. Falls das Fahrzeug über eine Anhängerkupplung
verfügt, ist der rechte Riemen F3 zu befestigen, wie
in dargestellt.
ACHTUNG
In einigen Fällen besitzt der untere Teil der Heckklappe
oder des Kofferraumdeckels keine Umrandung zur
Fixierung des Hakens. Verwenden Sie in diesem Fall
den Adapter I , falls er zum Lieferumfang gehört, und
folgen Sie dem Schema aus (ist der Adapter I nicht in
der Verpackung des Fahrradträgers enthalten, kann er
separat beim Händler erworben werden).
17
5
5
20 21 22
19
23
24
18
F3
F3
F3
OK
19 24
20 21 22
23
1
2
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Peruzzo Firenze 660 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Peruzzo Firenze 660 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 4.25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Peruzzo Firenze 660

Peruzzo Firenze 660 Additional guide - All languages - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info