91
Built in
(CKB740)
Electrical connection
For the connection, use an approved cable, in accordance with the regulations.
The cable casing should be of rubber. There is a label on the underside of the
appliance with the wiring diagrams. The connection terminals are accessible
once you have opened the junction box on the underneath. The junction box
cover can be opened with a screwdriver.
If you want to make a fixed connection, make sure that a multi-polar switch with
a contact separation of at least 3 mm is fitted in the supply line.
Power setting table
installation guide
Type of hob CKB740
Cooklight
x
Electrical connection 230 V - 50 Hz
Power of element
Front left 2300 W
Rear left 1200 W
Rear right 2000 W
Front right 1200 W
90
installation guide
Turn the hob over and allow the appliance to
sink into the opening.
Secure the hob using the fasteners supplied.
In the case of worktops thinner than 40 mm a filler block has to be used
between the fasteners and the worktop. The screws must be screwed into the
pressed holes.
Connecting up and checking hob
Connect the electricity supply to the oven or the operating panel by inserting
the plug in the socket (making sure that the plug clicks firmly into place).
Test to check the hob is operational.
