14
Enter a desired function command as shown on the next page.
You can program the following system items using the handset near the base unit. The display
shows the instructions. After selecting “
Setting Base
”, then “
System
”, enter the base unit PIN.
You can enter a desired function command. See the corresponding pages for function details.
Make sure that the power is ON (p. 13) and the unit is in the standby mode.
Caller ID
New Phonebook
Message Waiting
Call Pick Up
Setting Handset
H
Setting Base
<Standby mode>
<Function menu>
*
Press .
Base 1
12 New Calls
12.05 13:58
H
System
Day/Night
Service
<Function menu>
*
Press .
Enter Base PIN
:
Press .
•
You can exit the programming mode any time by pressing and also can return to
“
Input Command
” by pressing .
•
When programming is completed, a beep sounds.
Enter the 4-digit base unit PIN (p. 83).
•
The factory preset is 0000.
To select the day/night mode (p. 30)
To use ISDN supplementary service (p. 64)
Summary of Programmable Functions
While programming:
*
To select a desired function item, press or until
the arrow points to the item. Then press to go to the
next step.
•
You can press to go to the next menu of the
function menu instead of pressing .
•
To return to the previous step during programming, press
To view the Caller List (p. 55)
To store names and numbers in the phonebook (p. 41)
To use message waiting feature (p. 53)
To pick up the call (p. 87)
To set the handset programming (p. 16)
Input Command
KX-TCD706SLS(E)-2Preparation2 01.1.30 10:37 AM Page 14
