Chapter 1 Preparation
13
Base 1
10 New Calls
12.05 13:58
Turning the Power ON
To turn the power OFF, press and hold
until a beep sounds.
•
The display will go blank.
•
The handset will not ring.
•
When the power is OFF, the base unit will ring
only when the call distribution is set to “ALL”
(p. 32) or the intercept routing is set to “ON”
(p. 88).
Press and hold .
•
After all the possible configurations briefly
appear, the display will change to the following.
Then the handset is in the standby mode.
#
The current connected base unit number:
You can choose whether to display the
base unit number, handset number or no
display in the standby mode by
programming (p. 88).
$
The number of new Caller ID calls received
(p. 54):
If there is no call received,
$
will go blank.
%
The current date and time:
Automatic Date/Time Adjustment
Date and time are assigned automatically
by the ISDN service provider you contract
to when you make the first external call
and the other party answers, but not a first
receiving incoming external call. This
feature is not available if your ISDN service
provider does not provide the service.
#
$
%
If a power failure occurs, the incorrect
date/time will be shown. The date/time will be
adjusted if you make a call.
KX-TCD706SLS(E)-2Preparation2 01.1.30 10:37 AM Page 13
