107
Chapter 7
Useful Information
Problem
While programming or searching, the unit
starts to ring and stops the program/search.
The unit does not display the caller’s
phone numbers.
The display goes to the standby mode while
viewing the Caller List or phonebook.
does not function.
The paged handset does not answer.
While using the intercom, two tones
sound.
The unit misdials when connected to a PBX.
You cannot register the handset in the
base unit.
When redialling with pressing and
, you cannot talk to the other party.
Remedy
•To answer the call, press . Start again from the
beginning after hanging up.
•Other telephone equipment may be interfering with
your telephone. Disconnect it. Try again.
•Other electrical appliances connected to the same
outlet may be interfering with the Caller ID
information. Telephone line noise may be affecting
the Caller ID information.
•Do not pause for over 60 seconds while searching.
•There are no items in the Caller List or Phonebook.
•The handset is too far from the base unit.
•The handset is engaged in an outside call or is
viewing the Caller List.
•The handset is not in the same radio area.
•The handset is engaged in an outside call.
•The handset has been cancelled or has not been
registered. Register the handset in the base unit
(p. 95).
•
A call is being received. To answer, press then
.
•Check the pause function (p. 48).
•The base unit has registered a maximum of
6 handsets or the handset has registered a maximum
of 4 base units.
•There is interference from other electrical units.
Locate the handset and base unit away from them.
•You must finish registration within 1 minute after a
confirmation tone sounds, or programming will be
cancelled (p. 95).
•Press .
KX-TCD735EM(E)-5(101~114) 01.10.22 16:17 Page 107
