Installation
Mount the siren on a wall using the
holes in the rear cover.
Note:
R The strobe light flashes when the
siren sounds. Mount the siren in a
location where its strobe light will be
visible.
R Mount the siren on the stable
location where the siren can be
adequately supported when
mounting.
R Mount the siren securely to a wall.
Vibrations may cause it to fall if it is
not secured.
R Do not mount siren on a soft
material. It may fall down, break or
cause injury.
R Do not mount the siren on the
following places: gypsum board,
ALC (autoclaved lightweight cellular
concrete), concrete block, plywood
less than 25.4 mm (1 inch) thick, etc.
R Use only the supplied Panasonic AC
adaptor PNLV236.
1 R
emove the rear cover by
pressing the upper sides of the
cover (A) and sliding it down (B).