457746
100
Zoom out
Zoom in
Previous page
1/120
Next page
Troubleshooting
VQT3C73
100
Troubleshooting guide
Before requesting service, make the following checks. If
the problem still persists, consult your dealer for
instructions.
Updating to the latest software (firmware) may solve the
problem. (> 97)
The unit doesn’t work.
One of the unit’s safety devices may have been
activated.
Reset the unit as follows:
1 Press [Í/I] on the main unit to switch the unit to
standby.
If the unit doesn’t switch to standby, press [Í/I] on
the main unit for about 3 seconds. The unit is
forcibly switched to standby.
Alternatively, disconnect the AC mains lead, wait
one minute, then reconnect it.
2 Press [Í/I] on the main unit to switch it on. If the unit
still cannot be operated, consult the dealer.
Cannot eject a disc.
The unit may have a problem.
1 While the unit is off, press and hold [OK], the yellow
button and the blue button on the remote control at
the same time for more than 5 seconds.
00 RET” is displayed on the units display.
2 Repeatedly press [1] (right) on the remote control or
[Í/I] on the main unit until “06 FTO” is displayed on
the unit’s display.
3 Press [OK] on the remote control or
[< OPEN/CLOSE] on the main unit.
The unit is turned off automatically.
¾ If you connected this unit to a “HDAVI Control
compatible TV with an HDMI cable, or connected this unit
to a Q Link-compatible TV with a fully wired 21-pin Scart
cable, this unit will be automatically set to standby mode
when the TV is set to standby mode.
The unit does not turn on when pressing
[Í].
¾ Linked timer recordings with external equipment is in
recording standby (“EXT-L on the unit’s display blinks
when [Í] is pressed). Press [EXT LINK] to cancel the
recording standby.
The display is dim.
¾ Change “Unit’s Display”. (> 90)
“0:00 is flashing on the unit’s display.
¾ Set the clock. (> 95)
The time recorded on the disc and the
available time shown do not add up.
¾ [DVD-R] [+R] If you record or edit about 200 times or more,
the remaining capacity of the disc is reduced and then
recording or editing may be disabled (for the second
layer on DVD-R DL and +R DL, this happens after about
60 times).
¾ Available disc space display may be different from actual.
Varying may be large especially when recorded in DR
mode.
The clock does not display on the unit when
switched to standby.
¾ The clock does not display when “Power Save in
Standby” is activated. Ensure “Power Save in Standby is
set to “Off”. (> 94)
The followings do not indicate a problem with this
unit:
Regular disc rotating sounds or louder rotating sounds
when recording or high speed copying.
Poor reception due to atmospheric conditions.
Image disturbance during search.
Image disturbance when replacing 3D discs.
Interruptions in reception due to periodic broadcasting
breaks.
When the unit is turned on or off, there may be an
unexpected sound. This does not indicate a problem
with this unit.
Power
Displays
DMRBST800700701EG_eng.book 100 ページ 2011年4月26日 火曜日 午後5時27分
100


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic DMR-BST700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic DMR-BST700 in the language / languages: English as an attachment in your email.

The manual is 5,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic DMR-BST700

Panasonic DMR-BST700 User Manual - German - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info