13
12
E
N
G
L
I
S
H
CQ-D5501N
12
11
E
N
G
L
I
S
H
CQ-D5501N
General (Main Unit) (continued)
Open the Face Plate
Press [u] (OPEN).
Note:
¡The face plate automatically closes after a warning alarm
sounds if no operation is performed for approximately
20 seconds.
¡ When a disc is already loaded ( lights), the disc
will be ejected after the face plate fully opens.
(Disc Eject a Page 24)
Close the Face Plate
Press [u] (OPEN).
Face Plate Angle (Tilt)
Press and hold [u] (TILT) until you hear a beep (approxi-
mately 1 second) from the speaker output, then release it.
Set the face plate to the position at which it is easy to read
what is on the display. Each time the above operation is
repeated, the face plate angle changes in the sequence
shown below.
Note:
¡The positions specified at “Face Plate Angle (Tilt)” are
memorized even after the following operations.
¡Open/close
¡ACC on/off
¡Power on/off
Clock Display (at Power off)
When the power of the unit is set to OFF, press [DISP].
(ACC ON)
(Clock time) (Default)
(Display off)
When the power is set to ON, refer to the description for
each source mode.
Clock Setting
The 24-hour system is used for the clock.
Note:
¡ Adjust the clock when
“
NO CT
”
appears on the screen.
Select the radio AM (LW/MW) mode. (a Page 16)
Frequency
Press and hold [DISP] for more than 2 seconds.
Hour blinks
Adjust the hour.
[[]: put forward hour.
[]]: put back hour.
Hour entered
Press [DISP].
Minute blinks
Adjust the minute.
[[]: put forward minute.
[]]: put back minute.
Minute entered
Press [DISP].
Completed
Note:
¡ When a broadcast of FM Radio Data System is received,
the clock is adjusted automatically by the Clock Time
Service. (a Page 18)
