517568
67
Zoom out
Zoom in
Previous page
1/160
Next page
Advanced Operations
En-67
Operating
procedure
( page 61)
Note
These settings cannot be calibrated when the AV receiver
is muted.
Speakers that you set to “No” or “None” in
“Speaker Configuration” cannot be selected ( page 65).
When the “Powered Zone 3” setting is set to “Yes
( page 65) while Powered Zone 2 is enabled
( page 84), the surround back speakers cannot be used.
When the “Speakers Type(Front)” setting is set to
Bi-Amp” or “Digital Crossover” while Powered Zone 2 is
enabled ( page 84), the surround back speakers cannot
be used.
The test tone is output at the standard level for THX, which
is 0 dB (absolute volume setting 82). If you normally listen
at volume settings below this, be careful because the test
tone will be much louder.
*1
For the center speaker and subwoofer, the level settings
made by using the Quick Setup are saved in this menu
( page 59).
Tip
If you’re using a handheld sound level meter, adjust the level
of each speaker so that it reads 75 dB SPL at the listening
position, measured with C-weighting and slow reading.
Equalizer Settings
With the Equalizer settings, you can adjust the tone of
speakers individually with a 7-band equalizer. The
volume of each speaker can be set.
Manual Equalizer
` On:
You can adjust the equalizer for each speaker
manually. Continue with the following procedure:
` Off
:
Tone off, response flat.
Note
When the Direct or Pure Audio listening mode is selected,
the equalizer settings have no effect.
If “Audyssey” is enabled, it prevails over this setting
( page 71).
THX Audio Setup
Surr Back Speaker Spacing
` <1ft (<0.3m)
` 1ft-4ft (0.3m-1.2m)
` >4ft (>1.2m)
You can specify the distance between your surround
back speakers.
Note
Cannot be set if:
–“Surround Back” is set to “None” ( page 65).
–“Surround Back Ch” is set to “1ch” ( page 66).
–ThePowered Zone 3” setting is set to “Yes
( page 65) while Powered Zone 2 is enabled
( page 84).
–TheSpeakers Type(Front)” setting is set to “Bi-Amp” or
Digital Crossover” while Powered Zone 2 is enabled
( page 84).
THX Ultra2/Select2 Subwoofer
` No
` Yes
If you’re using a THX-certified subwoofer, set this
setting to “Yes”.
Note
If the “Subwoofer” setting is set to “No”, this setting cannot
be selected ( page 65).
BGC
` Off
` On
If your listening room layout (for practical or aesthetic
reasons) locates most of the listeners close to the
rear wall, the resulting bass level can be sufficiently
reinforced by the boundary that the overall sound
becomes “boomy”. THX Select2 Plus receivers
contain a Boundary Gain Compensation (BGC)
feature to improve bass balance.
Note
This setting is only available if “THX Ultra2/Select2
Subwoofer is set to “Yes”.
If the “Subwoofer” setting is set to “No”, this setting cannot
be selected ( page 65).
Loudness Plus
` Off
` On
When the “Loudness Plus” setting is set to “On”, it is
possible to enjoy even subtle nuances of audio
expression at low volume. This is only available when
the THX listening mode is selected.
1
Press w to select “Channel”, and then use
e/r to select a speaker.
2
Use q/w to select a frequency, and then use
the e/r to adjust the level at that frequency.
The volume at each frequency can be adjusted
from –6dB to 0dB
to +6dB in 1 dB steps.
Tip
You can select: “63Hz”, “160Hz”, “400Hz”, “1kHz”,
2.5kHz”, “6.3kHz”, or “16kHz”. And for the subwoofer,
25Hz”, “40Hz”, “63Hz”, “100Hz”, or “160Hz”.
Low frequencies (e.g., 63 Hz) affect bass sounds; high
frequencies (e.g., 16 kHz) affect treble sounds.
3
Use q to select “Channel”, and then use e/r
to select another speaker.
Repeat steps 1 and 2 for each speaker.
You cannot select speakers that you set to “No
or “None” in the “Speaker Configuration”
( page 65).
67


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-NR929 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-NR929 in the language / languages: English as an attachment in your email.

The manual is 4,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-NR929

Onkyo TX-NR929 Quick start guide - English - 4 pages

Onkyo TX-NR929 Quick start guide - German - 4 pages

Onkyo TX-NR929 User Manual - German - 160 pages

Onkyo TX-NR929 Quick start guide - Dutch - 4 pages

Onkyo TX-NR929 User Manual - Dutch - 160 pages

Onkyo TX-NR929 User Manual - French - 160 pages

Onkyo TX-NR929 User Manual - French - 4 pages

Onkyo TX-NR929 User Manual - Italian - 156 pages

Onkyo TX-NR929 Quick start guide - Italian - 4 pages

Onkyo TX-NR929 User Manual - Swedish - 160 pages

Onkyo TX-NR929 Quick start guide - Swedish - 4 pages

Onkyo TX-NR929 User Manual - Spanish - 160 pages

Onkyo TX-NR929 Quick start guide - Spanish - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info