66920
33
Zoom out
Zoom in
Previous page
1/36
Next page
33
Troubleshooting
—Continued
The remote controller doesnt work
Make sure that the batteries are installed with the cor-
rect polarity (page 5).
Install new batteries. Dont mix different types of bat-
teries or old and new batteries (page 5).
Make sure that the remote controller is not too far
away from the receiver, and that theres no obstruction
between the remote controller and the receivers
remote control sensor (page 10).
Make sure that the receiver is not subjected to direct
sunshine or inverter-type orescent lights. Relocate if
necessary (page 10).
Cant control other components
If youve connected an -capable Onkyo DS-A1
Remote Interactive Dock to the TAPE 1 or VIDEO
jacks on the TX-8522 (or TAPE 1 or LINE 2 jacks on
the TX-8222), for the remote controller to work prop-
erly, you must set the input display to HDD (see
page 20).
If its an Onkyo component, make sure that the
cable and analog audio cable are connected properly.
Connecting only an cable wont work (page 19).
With some components, certain buttons may not work
as expected, and some may not work at all.
To control an Onkyo component thats connected via
, point the remote controller at the receiver.
Cant record
On your recorder, make sure the correct input is
selected.
To prevent signal loops and damage to the receiver,
input signals are not fed through to outputs with the
same name (e.g., TAPE IN to TAPE OUT, or VIDEO
IN to VIDEO OUT).
When the Pure Audio function is selected, recording is
not possible because no video signals are output. Dis-
able the function before recording.
The display doesnt work
The display is turned off when the Pure Audio
(TX-8522) function is selected.
The functions dont work
To use , you must make an connection and an
analog audio connection (RCA) between the compo-
nent and receiver, even if they are connected digitally
(page 19).
Remote Controller
Recording
Others
The receiver contains a microcomputer for signal
processing and control functions. In very rare
situations, severe interference, noise from an external
source, or static electricity may cause it to lockup. In the
unlikely event that this happens, unplug the power cord
from the wall outlet, wait at least five seconds, and then
plug it back in again.
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit’s malfunction. Before you record important
data, make sure that the material will be recorded
correctly.
Before disconnecting the power cord from the wall
outlet, set the receiver to Standby.
Memory Backup
The receiver uses a battery-less memory backup
system in order to retain radio presets and other
settings when it’s unplugged or in the case of a power
failure. Although no batteries are required, the receiver
must be plugged into an AC outlet in order to charge the
backup system. Once it has been charged, the receiver
will retain the settings for several weeks, although this
depends on the environment and will be shorter in
humid climates.
TX-85228222_En.book 33 ページ 2006年5月4日 木曜日 午前11時51分
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo TX-8522 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo TX-8522 in the language / languages: English as an attachment in your email.

The manual is 3,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo TX-8522

Onkyo TX-8522 User Manual - German - 72 pages

Onkyo TX-8522 User Manual - Dutch - 72 pages

Onkyo TX-8522 User Manual - Dutch, Italian - 72 pages

Onkyo TX-8522 User Manual - Swedish - 72 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info