803236

Nuk Eco Control Audio 530D - 10256439 Manual

15
Zoom out
Zoom in
Previous page
1/22
Next page
37
hear your baby nor see the level of noise in
the nursery. We therefore recommend that
you always leave at least one transmission
active.
6.6 Using the VOX function to
adjust the transmission
sensitivity
Babies make a lot of different noises. These
can range from loud breathing through
babbling to calling or loud crying. The VOX
function can be set up in such a way that
only loud sounds such as crying or calling
are transmitted while quieter sounds are not
registered.
The VOX function sets up the transmission
sensitivity of the microphone. The higher the
VOX level the more sensitive the device is to
noises.
1. You activate the VOX function by briefly
pressing the VOX button 20.
The LEDs 19 indicate the sensitivity of
the current setting by flashing.
2. You can increase or decrease the
transmission sensitivity by pressing one
of the VOL + 13 or VOL - 14 buttons. The
number of flashing LEDs 19 corresponds
to the selected level:
– VOX level 1 = extremely low sensitivity,
reacts only if baby screams very loudly;
– VOX level 2 = low sensitivity, reacts if
baby screams loudly;
– VOX level 3 = normal sensitivity, reacts
if baby cries normally;
– VOX level 4 = high sensitivity, reacts
even to slight sounds;
– VOX level 5 = Eco-Mode is switched
off. The unit is set to transmit continu-
ously.
You can set up the volume at which the parent
unit should output the transmitted sounds
using the two VOL + 15 and VOL - 16 buttons
(see "6.4 Adjusting the volume control" on
page 36).
Note: After activating the VOX function, you
have about two seconds to alter the
transmission sensitivity. The device will then
automatically switch back to transmitting
sounds. You can see this has happened
because the LEDs 19 will no longer be
flashing, and the VOL + 13 and VOL - 14
buttons now only modify the volume.
Caution! In continuous transmission mode
at VOX level 5, all sounds are transmitted
continuously. When the baby is sleeping
peacefully, the volume is automatically
reduced to its lowest level after a few
seconds to minimise background noise. As
soon as the child begins to make a noise,
the volume automatically returns to its
previous setting.
6.7 Talking to your baby
You can use the “Talk back” function to
speak to your baby.
1. Hold down the TALK 22 button on the
parent unit.
The display 15 shows
the TALK symbol.
2. At the same time, speak into the
microphone 25 on the parent unit.
Your baby can now hear your voice from
the loudspeaker 2 on the baby unit.
3. Release the TALK 22 button in order to
hear the baby’s reaction.
The TALK symbol disappears.
Notes:
– If the baby unit 1 is in Eco-Mode, this
function is deactivated so that you do
not inadvertently wake your baby. In
this case, two consecutive beeps will
remind you that the talk-back function
is currently not available.
– The display 15
shows a flashing
TALK symbol.
– If the volume of the parent unit is set to
“MUTE” (see "6.5 Mute setting" on
page 36), it will automatically be
increased to level 1 as soon as you
press the TALK 22 button.
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nuk Eco Control Audio 530D - 10256439 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nuk Eco Control Audio 530D - 10256439 in the language / languages: English as an attachment in your email.

The manual is 0.42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info