19480
39
Zoom out
Zoom in
Previous page
1/60
Next page
INSTRUCTIONS FOR USE
32401106(1)2004-04 A 9
VACUUM CLEANER FOR
ASBESTOS
On vacuum cleaners with an accessory for the removal of
asbestos dust, the ABS container insert or the protective
bag system must always be used. An exhaust connection
must be attached to the side outlet, through which air can
be exhausted from the working area. The exhaust hose
can be directed to the open air or to a ventilation system
installed in the working area.
The exhaust connection for the air outlet must be fitted
with a 70 mm PUR H hose with a length of < 5 m. This
hose is contained in the Asbestos Kit, which can be
supplied for the machine. As already mentioned, the hose
can either be exhausted directly to the open air or to a
ventilation system installed in the working area.
When transporting the machine you must make sure that
it has been cleaned in accordance with the regulations
stipulated in TRGS 519. The machine can also be
transported in a sealed container from which no
contaminated dust can escape.
Filter replacement
Make sure that the filter is covered with a suitable plastic
bag before it is removed.
Remove the suction pipe “1” from the lower connection.
If the filter assembly is very heavy, remove the upper
cover and lift the assembly from the machine using the two
handles provided. Unscrew the clamp, which attaches the
filter to the basket, and lift the basket from the filter.
Rotate the filter and reveal the plastic strip “2”.
Place the filter in a plastic bag, cut the plastic strip and free
the basket from the filter.
Seal the plastic bag containing the filter.
If the filter is soiled by poisonous or otherwise dangerous
dust do not throw it away. Hand it to an authority, which is
authorised for the disposal of this type of waste.
Take particular care when replacing the main filter or the
complete filter and wear a P3-type mask.
Obtain a filter with the same characteristics as the old filter
and proceed as follows: (Fig. 17).
Fit the filter lock and the sealing ring of the old filter to the
new filter.
Insert the cage “4” and secure the filter using the plastic
strips “2” on the bottom of the filter.
Fit the filter rods in the filter shaking system and tighten the
screw.
Fit the upper cover on the filter unit.
Re-insert the filter unit into the machine.
Re-attach the suction pipe “1” in its original position.
Fix the clamp, which holds the filter unit on the machine.
ABSOLUTE FILTER
HEPA filter “1” must be installed when the vacuum must
operate in clean-room environments, when a high degree
of purity is required or when it must treat materials that are
dangerous for the operator.
This filter is installed in the filter compartment on the top of
machine, between the primary filter and the blower unit.
This allows the machines to achieve 99.995% MPP
efficiency at a particle size of 0.3 Micron, in retaining the
particles that escape the primary filter.
This value was gauged by means of the D.O.P. method.
NOTE
If the machine is to be used for the suction
removal of asbestos dust, either the ABS
container or the protective bag system must
be used.
ATTENTION!
The replacement of the filter is an important
procedure.
The filter must be replaced by another filter
with the same characteristics and the same
filter surface and category. If these rules are
not followed the vacuum cleaner may not
function correctly.
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk IV150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk IV150 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nilfisk IV150

Nilfisk IV150 User Manual - Italian, Portuguese, Spanish - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info