609307

Nilfisk-ALTO MULTICLEANER 7-53 Manual

12
Zoom out
Zoom in
Previous page
1/29
Next page
13
MULTICLEANER 7-53
Original Instructions
6.5 Ambient temperature,
operation/storage
During operation the ambient temperature must always be above
+10 degrees Celsius. During storage the temperature must never
go below freezing point unless the MULTICLEANER has been frost
protected as described in section 7.5.1.
6.6 Inventory in aisle The sides of the inventory in the aisle, towards which the MUL-
TICLEANER regulates its course by means of the two ultrasonic
sensors must be present and even. The ultrasonic sensors can be
regulated up and down and must be set to touch on an even side.
All gaps exceeding 50 mm in the inventory side should be covered.
If the MULTICLEANER cannot detect the inventory side, it will
proceed forwards for approximately 10 seconds. Then the MULTI-
CLEANER will report an error because of a missing inventory side.
The end wall of the aisle against which the rubber bumpers of the
MULTICLEANER are activated, must be plane and without any
sharp objects which may puncture the bumpers. The height of the
plane surface must be 450 mm at a minimum. Profiled end walls
such as steel gates must be covered with a plate.
If the tower and the arm are placed in a position so that during the
aisle washing they protrude backwards above the bumper, an object
must be placed so that the rear bumper can be activated during
backward movement.
6.7 Floor finish in aisle In connection with washing of the aisle it is important that the dirt
which the MULTICLEANER drags along can be led away in a natu-
ral way as the machine is progressing. A slotted floor is preferred off
course, but if it is a solid floor, there must be a clearance under the
gates of 40 mm at a minimum. If it is a combination of a slotted and
a solid floor, a clearance below the gates is not necessary.
Note! Large amounts of muck and foreign bodies as for instance
remains of concrete and stones must be removed before starting
the cleaning.
6.8 Pens The optimal layout of a pen will be :
The depth of the pen does not increase 4.8 m.
The plastic inventory and the latch do not exceed 1000 mm in the
height.
The stomas are perpendicular to the aisle.
The width of the aisle is 800 mm.
Stomas in the aisle.
Automatic feeders, down-leads and water pipes are placed at least
2 m inside the pen from the front edge of the inventory side in the
aisle, enabling the washing arm to reach the middle of the pen.
On potential rest areas to the stoma area there is a minimum gradi-
ent of 3%.
3/4" water connection at one of the ends of the aisle. Availability of
17 l water per minute.
CEE-plug at the end of the aisle, 400 V / 16 A.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO MULTICLEANER 7-53 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO MULTICLEANER 7-53 in the language / languages: English as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info