609307
11
Zoom out
Zoom in
Previous page
1/29
Next page
12
MULTICLEANER 7-53
Original Instructions
5.10 Safety device
5.10.1 Emergency switch
The robot features an emergency switch in each end. Thus it will
always be possible to interrupt all functions in case of an emer-
gency. These press buttons are connected to an emergency module
ensuring that no motors can be started until the user has made a
delibe rate action by re-setting the module. The module is re-set by
pressing the arrow next to the display.
6 Requirements for the existing
installation/inventory
6.1 Power supply The machine must be connected to a CEE wall plug, 400 volts, 16
amp or extension cord from the same of at least 2.5 square milli-
metres.
The extension cord must only be used for supplying the robot and
it must be fixed. It must not be used for the extension of the internal
cable reel to increase the reach of the machine as the consequence
will be that the cord is dragged across the concrete floor which is
not allowed according to the Heavy Current Regulation, paragraph
204-1, §14, EN 60204-1. The robot must not be secured with more
than 16 amp. If there is only a 32 amp wall plug available, the fuses
must be replaced by 16 amp fuses.
6.2 Water The required water volume is 16.5 l/min. The inlet pressure must be
max./min. 10/1 bar and the water inlet temperature must not exceed
60°C. You should know that the warmer the water is on the inlet
side, the faster the components in the MULTICLEANER will be worn
out. Therefore these components must be checked more frequently
than mentioned in the maintenance section if you use hot water.
Connect the water hose, ¾", by means of the quick coupling placed
below the front bumper. The quick coupling also functions as a pivot
joint always ensuring a natural hose run to minimise the risk of
bending the water hose.
6.3 Running sands filter If the connected water supply contains running sand, a running
sand filter must be mounted. Damages or abnormal wear caused by
running sand are not covered by the warranty or service contracts.
Clean or replace the filter as needed.
6.4 Hose dimension /quality The robot must be supplied with water from a two-layered ¾" water
hose. No joints on the hose between the MULTICLEANER and the
water outlet are allowed. For mounting of connecting branch and
quick coupling use hose clips of stainless steel.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO MULTICLEANER 7-53 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO MULTICLEANER 7-53 in the language / languages: English as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info