Manual Niagara B264 Standalone Encoder (page 25 of 120) (English)

641176

Zoom out

Zoom in

1/120

Configuration Tabs

Network Configuration Interfaces Tab

This tab allows the configuration of the individual streaming ports.

The following parameters can be configured:

 Alarm on Link Loss: If set to Yes, the card will raise an alarm if this Ethernet interface

loses link. The Card State indicator in Dashboard™ and the front Status LED will both

be red. If set to No, the card will still report loss of link in the Statistics page but no

alarm will be raised. Niagara Video recommends turning on the alarm for ports that are

in use; only turn it off if you do not plan to connect that port to a network.

 IP Address: Enter the desired IP address for this Ethernet port. In the B264, this IP

address cannot be the same as the Control Port IP Address (see the Control Port

Configuration Tab).

 Subnet Mask: Enter the desired subnet mask for this Ethernet port.

 Default Gateway: Enter the desired default gateway for this Ethernet port, or 0.0.0.0 if

no gateway is available.

 Interface Settings: If you make any changes to the IP Address, Subnet Mask and/or

Default Encoder fields, the Apply and Cancel buttons become active. The changes only

take effect when you press the Apply button. Pressing the Cancel button reverts the

fields back to their original values. Note that the B264 will check the consistency of the

data entered and will reject invalid combinations (i.e., combinations where the gateway is

outside the interface subnet). Once the Apply button is pressed, a status message appears

just below the Cancel button, as follows:

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Niagara B264 Standalone Encoder in the language / languages: English as an attachment in your email.

The manual is 3,46 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Niagara B264 Standalone Encoder

Niagara B264 Standalone Encoder Quick start guide - English - 4 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Niagara B264 Standalone Encoder Manual

Product: