629274
26
Zoom out
Zoom in
Previous page
1/36
Next page
26 © 2015 UTC Fire & Security Americas Corporation, Inc. All rights reserved.
Partition Removal via Panel Programming
Note: NetworX panel default configuration has all zones assigned to
partition 1. The result of this default configuration is the GUI and UltraSync
application displays all of these zones to the end user, even if they are not
installed in the panel. It is recommended practice to “remove” unused
zones from the NetworX panel. This is accomplished by removing the
partition assignment from all unused zones. To accomplish this task, you
will have to access the panel via the keypad. Deselect partition 1 for zones
that are not installed in the panel. Access device 0, Location 26-36 (even
locations only) to accomplish this task. See the table below for more
information.
Zone Partition Assignment
Device
Zones
Location
Segment
Action
0
1-8
26
1-8
Deselect all partitions from each
segment if zone is not installed in the panel
9-16
28
1-8
17-24
30
1-8
25-32
32
1-8
33-40
34
1-8
41-48
36
1-8
Example, Zone 26 would be programmed with Location 32, Segment 2.
Configuring the NX-595E with the UltraSync application
The configuration procedure with the UltraSync application is identical to the
procedure described above for a web browser. Follow the instructions below to
install and configure the UltraSync application.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NetworX NX-595E IP Communication Module at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NetworX NX-595E IP Communication Module in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info