© 2015 UTC Fire & Security Americas Corporation, Inc. All rights reserved. 25
Additional users on the NetworX panel must be assigned a name on this page to
permit them access to the UltraSync application. By default User 1 is the only user
that is pre-assigned a user name in the NX-595E.
PIN codes can also be changed or added from this page.
PIN codes are generally four digits in length, but can be configured to be six digits
in length if this level of security is required. Refer to the NetworX panel installation
manual for additional information.
The User Authority determines the options available to that user:
• Arm Only – allows the user to only arm partitions and prevents disarming
• Schedule – allows disarm only during Open Window and arming after Close
Window (see NetworX installation manual)
• Master – allows this user to create, delete or modify users. Master access
always allows arming and disarming. Users can only assign partitions to users
they have access to.
• Arm/Disarm – allows this user to arm and disarm partitions they have access to
• Bypass – allows this user to bypass zones
• Report – send open and close reports when this user arms and disarms
partitions
• User Partitions – select the partitions the user will be allowed to access and
control.
Note: The “User 1” user name is programmed into the NX-595E by default for User
1 in the NetworX panel. A user name must be created for all other users if they are
to have access to the panel via the UltraSync application. The Master user/User 1
should change their user name to something more user friendly after they log in.
The installer account is for installer access only and allows panel programming. It is
not recommended to provide this code to the end-user.
