470016

Navman FISH 4150 Manual

19
Zoom out
Zoom in
Previous page
1/25
Next page
FISH 4100 Installation and Operation Manual NAVMAN
19
Warning
1 Amp fuses must be positioned where shown in
the wiring diagrams.
If possible, route the transducer cables away from
other wiring on the boat. Electrical noise from engine
wiring, bilge pumps and other electrical equipment
can affect the unit.
The shortest and most direct connection to the boat's
battery helps to minimize voltage drop. Do not lay
cable along the bilge.
Two wiring options are described in this section:
· Basic Wiring. This does not start the fishfinder
automatically when the boat ignition is
switched on and it disables the engine hours
counter.
· Auto Power Wiring. This must be used for
engine hours and fuel computer options.
Important
The NAVMAN fishfinder must be run off a 12 volt
battery and must not be run off a circuit without a
battery.
Basic Wiring
This option is possible on both the FISH 4100 and
the FISH 4150.
Auto Power Wiring
This option is possible on both the FISH 4100 and
the FISH 4150.
Note: Green and white wires are on the FISH 4150
only.
5-4 Wiring Connection
Fuse
Fuse
Fuse
Red
Yellow
Black
Main
switch
12 V DC
Black wire: Connect this to the negative battery
terminal.
Red Wire: Connect this to the 12 V positive battery
terminal after the main switch. Fit a 1 Amp fuse as
shown.
Yellow wire: Connect this to the black wire. This
disables the engine hours counter.
Power on the fishfinder manually whenever the main
switch is on.
Black wire: Connect this to the negative battery
terminal.
Red Wire: Connect this to the 12 V positive battery
terminal after the main switch. Fit a 1 Amp fuse as
shown.
Yellow Wire: To enable the engine hours counter and
start the fishfinder automatically when the ignition is
turned on, connect the yellow wire to the ignition
system, through a 1 Amp fuse. Note that the fishfinder
cannot be turned off while the ignition is on.
Flashing Light and/or External beeper
(FISH 4150 only)
Use the green wire on the FISH 4150, if desired, to
connect a secondary alarm indicator such as a
flashing light or a 12 V external beeper with a built in
drive circuit. Refer to the wiring diagram. If the
external beeper or light requires more than 250 mA
dc total, fit a 12 V relay. Consult your NAVMAN dealer
for more advice.
NMEA Instruments (FISH 4150 only)
Use the white wire on the FISH 4150, if desired, to
connect the fishfinder to other NMEA instruments
such as the NAVMAN depth repeater. See section
5-5 for more information.
White (NMEA out)
Green
External Beeper
or Light
Red
Yellow
Black
Main
switch
12 V DC
Ignition
switch
To ignition system
… 19 …


Need help? Post your question in this forum.

Forumrules
1

Forum

navman-fish-4150

Reset search

  • sono in possesso di un navman fish 4150 e da un po di tempo non riesco piu a leggere perche non visualizza gli sritti quindi non riesco ad utilizarlo . Mi sapete dire cosa sara successo
    Submitted on 31-12-2020 at 23:47

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman FISH 4150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman FISH 4150 in the language / languages: English as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman FISH 4150

Navman FISH 4150 Usermanual and installation guide - German - 27 pages

Navman FISH 4150 Usermanual and installation guide - Dutch - 25 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info