512550
4
Zoom out
Zoom in
Previous page
1/12
Next page
4
DEPTH 2100 Installation and Operation Manual
NAVMAN
Whenever power is applied the depth sounder is
active and water depth is displayed. If the sonar signal
does not show a bottom the display will indicate “- -”.
This can occur if the water is aerated or the maximum
depth is exceeded. Note: The maximum depth
decreases as boat speed increases.
Alarms
Two types of alarms can be set; the Deep Alarm and
the Shallow Alarm. The Deep Alarm can be set as
high as 184 metres (605 feet) while the Shallow
Alarm can be set as low as 0.3 metre (1 foot).
Whenever the water depth is greater than the Deep
Alarm setting and the alarm is enabled an alarm will
sound. The alarm repeats two short beeps and
alternates DAL and the water depth on the display.
Whenever the water depth is less than the Shallow
Alarm setting and the alarm is enabled an alarm will
sound. The alarm repeats a single long beep and
alternates SAL and the water depth on the display.
Alarms On/Off
Alarm settings are saved in memory.
To turn the alarm on, press (ON). An arrow on the
lower right corner of the display will show (next to the
Alarm Bell), to indicate that the alarms are on.
120
#
OFF
ON
^
V
To turn the alarms off, press (OFF). The arrow in
the lower right corner will extinguish.
120
#
OFF
V
Note: The arrow will flash if alarms are turned ON
but the shallow alarm is individually set to OFF.
See next section.
3. Use
and to change the value. If either
key is held depressed for more than one
second the reading will increase or decrease
rapidly.
4. When the alarm is set, exit by pressing both
Shallow Alarm
To set the shallow alarm:
1. Press
for three seconds. The display will
show:
SAL
OFF
ON
^
V
2. After a few seconds the
display will indicate the current
Shallow Alarm depth setting.
Press for
3 Seconds
1 Operation
850
Press for 3
Seconds
851
and simultaneously. Alternatively, if no
keys are pressed for a period of 5 seconds the
normal depth display will resume.
OFFON
^
V
Press simultaneously to exit
Note: If the reading is decreased to below
1.5 feet (or equivalent) the display will
show OFF and the alarm will be disabled. The
alarm can also be disabled by pressing both
and for 5 seconds. The word OFF will be
displayed but the alarm depth will be retained for
future use.
Deep Alarm
To set the deep alarm:
1. Press for three seconds. The display will
show:
dAL
OFF
V
2. After two seconds the display
will indicate the current Deep
Alarm depth setting.
3. Use
and to change the
value. If either key is held depressed for more
than one second the reading will increase or
decrease rapidly.
4. When the alarm is set, exit by pressing both
and simultaneously. Alternatively, if no keys
are pressed for a period of 5 seconds the
normal depth display will resume.
OFFON
^
V
Press simultaneously to exit
Note: If the reading is increased one step above
600 feet (or equivalent) the display will
show OFF and the alarm will be disabled. The
alarm can also be disabled by pressing both
and for 5 seconds. The word OFF will be
displayed but the alarm depth will be retained for
future use.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Navman Depth 2100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Navman Depth 2100 in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Navman Depth 2100

Navman Depth 2100 User Manual - German - 10 pages

Navman Depth 2100 User Manual - Dutch - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info