765494

Mountfield EL 380 Li 48L Manual

33
Zoom out
Zoom in
Previous page
1/42
Next page
EN - 6
• When moving between work areas.
• When driving on grass free surfaces.
• Every time it is necessary to overcome an obstacle.
• Before adjusting the cutting height.
• Whenever you remove or reattach the grass catcher.
6.6 AFTER OPERATION (Fig.31÷33)
1.
IMPORTANT Remove the safety key whenever
the machine is unused or left unattended.
7. MAINTENANCE
The safety regulations to follow are described in
chap. 2. Strictly comply with these instructions to avoid
serious risks or dangers.
Before conducting any inspections, cleaning or
maintenance/adjustment interventions on the machine:
• Stop the machine.
• Remove the safety key, (never leave the
key in the ignition or within reach of
children or unauthorised persons).
• Remove the battery.
• Make sure that all moving parts have
come to a complete stop.
• Allow the motor to cool before
storing in an enclosed space.
• Use suitable clothing, protective
gloves and goggles.
• Read the relevant instructions.
7.1 BATTERY
7.1.1 Battery power reserve
Battery power reserve (the mowable lawn surface
before recharging is required) mainly depends on:
a. Environmental factors that cause
higher energy requirements:
– Mowing dense, high and/or wet grass.
b. Machine cutting width; the wider the
width, the greater the energy needed.
c. Operator behaviour that should be avoided:
– 
frequently whilst working.
– Setting a cutting height that is too
low for the lawn conditions.
– Working at a speed that is too high in relation
to the amount of grass to be removed.
NOTE During use, the battery is protected against
total drainage with a protective device that switches
o the machine and stops it from working.
To optimise battery power reserve,
it is always recommended to:
– Cut the grass when the lawn is dry.
– Cut the grass frequently so that it doesn’t grow too tall.
– Set a higher cutting height when the grass is very
tall, then set a lower height and cut the lawn again.
– Do not use the machine in “mulching”
mode when the grass is very tall.
If the need arises to use the machine for sessions which
exceed the capability of a standard battery, it is possible to:
– Purchase a second standard battery to immediately
replace the discharged battery, without
compromising the continuity of operations.
Purchase a battery with an extended power reserve
compared to the standard version (par. 13.2)..
7.1.2 Battery removal and recharging (Fig.31÷33)
NOTE The battery is equipped with a guard
that inhibits recharging if the environmental
temperature is not between 0 and +45 °C.
NOTE The battery can be recharged at any
time, even partially, with no risk of damaging it.
7.2 CLEANING 
Clean thoroughly following the instructions
below every time it is used.
7.2.1 Cleaning the machine (Fig.35÷38)
7.2.2 Cleaning the blade assembly
IMPORTANT Tilt the machine laterally and make
sure that it is stable before starting any work.
Remove grass debris and mud accumulated in
the chassis to prevent it from drying and causing
problems the next time the lawnmower is used.
7.2.3 Cleaning the grass catcher 
7.3 BLADE ÷
Do not touch the blade until the key has been
removed and the blade is completely stationary. Bear in
mind that, even though the key has been removed, the
blade can still move.
All work on the blade (disassembly, sharpening,
balancing, repairing, reassembly and/or replacing) are
demanding jobs that require special skills as well as
special tools; for safety reasons, these jobs are best
carried out at a Specialised Centre.
Make sure damaged, misshapen or worn blades
are replaced, together with its own screws in place to
preserve balance.
IMPORTANT Always use original blade bearing
the code indicated in the “Technical Data”.
Given product evolution, the blade listed in the “Technical
Data” table may be replaced in time with others having
similar interchangeable and operating safety features.
8. STORAGE
… 33 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mountfield EL 380 Li 48L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mountfield EL 380 Li 48L in the language / languages: English, Italian as an attachment in your email.

The manual is 10,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info