475319
97
Zoom out
Zoom in
Previous page
1/124
Next page
Chapter 7. Troubleshooting 97
IEEE 1394 Devices
Symptom Suggested Solution
10. Cannot record to or from the IEEE 1394 device,
including dubbed recordings.
• ToinitiatearecordingtoIEEE1394device,presstheREC key. The Record menu
displays allowing setup of the recording.
• Thesourcedevicefortherecordingisnotpoweredon.
• Whendubbing,thedestinationdevicefortherecordingisnotpoweredon.
• Thewrongmedium(analogtapefordigitalrecording,ordigitaltapefortheanalog
recording) is in the device.
• Theprogramiscopyprotected.
• Theprogramhasalreadybeenrecordedonceandthecopyprotectiononlyallows
one recording.
• Unapprovedsourcedeviceforcopyprotectedmaterial.
• Therecordingdevicecannotdecodethecopyrightsignalincludedinthesignal
source (try another device if available).
• Theplayingdevice(fordubbing)doesnotsupportcopyrightedmaterial.
• Sourceforrecordingiscopyrighted
• ToomanyIEEE1394devicesinnetwork.Insufficientbandwidthavailable.
Disconnect unused devices.
• SourceDevicehashigherspeed(S400)thanrecorddevice.Ifpossible,reverse
devices, play in the slower device and record in the faster device.
11. Cannot control the IEEE 1394 device from the
Transport Menu.
• Devicemaynotsupportthecommand.
• Selectedfunctionisgray(suchasRecordforaDVD,whichdoesnotsupportthe
Record function.
TV Guide On Screen
(see the separate TV Guide On Screen® Interactive Program Guide User’s Manual for detailed information)
Symptom Suggested Solution
1. TV Guide On Screen® system shows no program
listings.
• ProgramlistingsaredownloadedwhiletheTVisoffandthecable
box is left on. It may take up to 24 hours to begin to receive TV
program listings. It may take up to one week to receive all eight
days of TV program listings.
• InvalidZIPcodewasenteredattheinitialTVGuideOnScreen
system setup. Select NetCommand from the main TV menu, then
Guide and enter the correct ZIP code.
• ChecktheconnectionsbetweentheTVandtheTVGuideOn
Screen input (cable, antenna or cable box and IR cable). At least
one antenna connection must be associated with the TV Guide On
Screen system to receive program listings.
2. TV Guide On Screen system program listings
don’t match actual programs
• IncorrectZIPcodewasenteredatinitialTVGuidesystemsetup.
Select NetCommand menu, then Guide to enter the correct ZIP
code.
• Forcableprograms,theremaybemorethanonecablecompany
in your ZIP code. Refer to the TV Guide On Screen system manual
for instructions on the Setup Service.
3. TV Guide On Screen system does not change
channels on the cable box.
• CableboxisnotsetupinNetCommand.TheTVGuideOnScreen
system uses NetCommand to control the cable box and VCR. To
correct, select NetCommand from the main TV menu, then select
Change or Add on the NetCommand menu and select Cable Box.
• NetCommandIRemitterisnotinplaceorproperlypositionedin
front of the cable box remote sensor. See page 32.
97


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mitsubishi WD-62628 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mitsubishi WD-62628 in the language / languages: English as an attachment in your email.

The manual is 7,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info