10
- Voice activation (VOX):
This is the default enabling mode. To start an Inter- ›
com communication, simply start talking. The com-
munication will remain active for all the time you
are talking. If there is no conversation, the Inter-
com feature is automatically disabled after 1 minute.
To re-enable it, simply start talking again. When the Inter-
com is “VOX” activated, you can decide to disable it before
the predened time, simply by pressing the Intercom but-
ton once.
To disable the voice enabling mode, follow the instructions ›
provided in the “Special congurations” section.
Attention: when you use the Intercom feature, the rst
time you activate it (voice or manual) the communication
will be established with a short delay because of the fact
that the devices must rst recognize each other. After
that the communication will be immediately established.
Two Midland BT2 units can communicate up to a maximum
range of approximately 200 meters outdoors. It is therefore
possible to use BT2 as Intercom system for “BIKE-TO-BIKE”
communications between two riders. The maximum range
depends on the environment the units are being used in.
Using the telephone feature
To use the Telephone feature, be sure both units are turned
on and correctly paired together, following the pairing pro-
cedure described in section “Pairing the unit with a mobile
phone”.
Attention: information provided in this section refers to
the establishment of a direct communication between
the mobile phone and the BT2 unit. If the mobile phone is
connected via the GPS Sat-Nav, the mobile phone featu-
res can only be managed via the GPS itself.
Priority: Calls are always private and have a high priority,
which means that all other communications are temporarily
disabled when a call arrives and automatically re-enabled
once the call ends.
Answering a call
When you hear the phone ring, you can answer in two dif-
ferent ways:
Vocally:
Simply say one word to answer the call and start talking. Re-
membering that you can only do this if you answer the call
after the third Ring. (Be aware that some phones may not
support voice answering)
Manually:
Tap the “Phone” button and start speaking.
Attention: Remember that you can answer the call only
after the third Ring.
Rejecting a call
If you don’t wish to answer, you can let the mobile phone ring
or press the “Telephone” button for a few seconds (you will
hear one audio conrmation tone).
Making a call
There are several ways to make a call.
From the mobile keypad:
Dial the number on the mobile keypad:
Press “Send” on the mobile phone. ›
This way of calling should never be carried out whilst in ›
charge of a moving vehicle.
To redial the last number:
Press and hold “Telephone” button for 3 seconds in order ›
to redial the last number (you will hear one audio conrma-
tion tone).
To make a voice call:
Briey press “Telephone” button. If your mobile phone sup- ›
ports voice calls, you will be asked to spell the name of the
contact you wish to call.
The correct operation of this feature depends on the type of
helmet used (Open or closed faced) and on the speed you
are travelling at. We suggest you perform a few tests to de-
termine the best settings for you as an individual.
Attention: if you are listening the music using an MP3
Player connected via Bluetooth (A2DP protocol), you will
not be able to use the “Dial last number” and “Voice call”
commands, because these buttons are used to control
the MP3 player. Therefore, if you want to make a call, you
must rst disable the music by pressing the “Intercom”
button for 1 second (you will hear two audio conrmation
tone) before making the call.
Ending a call
There are several ways to end a call:
Wait for the called person to end the call. ›
Press the Telephone” button for 3 seconds (you will hear ›
an audio conrmation tone).
Press “End” button on the mobile phone. (This way of end- ›
