451403
16
Zoom out
Zoom in
Previous page
1/56
Next page
7.3 Installation of the blade guard in case of a saw blade diameter of 400 mm
If a 400 mm saw blade is used, the chip hood has to be
fixed one drilling level deeper on the chip case.
7.6 Setting of the ripping fence
The desired width of the cut is adjusted through sliding
the ripping fence. It can be read directly off scale.
Clamping is done by pushing down the eccentric clamp
lever.
7.5 Vertical adjustment of the saw blade
The height of the saw blade must never be adjusted
when the saw blade is still moving. The adjustment
handle must be turned to the left for about 30° . The
cutting height needed is now adjustable through sliding
the handle up and down. After releasing, the handle
clamping takes place through a built-in spring. The
desired cutting height can be read off the arc scale.
7.4 Changing the saw blade
- Disconnect from power before changing blade!
- Swing the locking switch to the side and remove the lid
of the chip thousing.
- Loosen and unscrew the locking screw with the
included tools.
Remove the lock flange and lift the saw blade from the
flange.
- Important !
Left-hand thread. Turn clockwise to loosen.
- Before fitting the new saw blade, clean the clamping
faces of the flange, and grease the thread slightly.
- When fitting the new saw blade, make sure the saw
teeth are showing in the correct direction. The locking
screw of the saw blade flange must be tightened
carefully and the lid of the chip case must be fixed on
its box and bolted.
Operation without the lid of the chip case poses
great danger of injury !
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Metabo BKH 400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Metabo BKH 400 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 6,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info