Manual Metabo BAS 600 (page 12 of 38) (English, German, Dutch, French)

451402

Zoom out

Zoom in

1/38

Fig. 8

Fig. 5

Fig. 6

3 Rip Fence

Fit the self-adhesive scale into the recess of the guide

extrusion. Ensure the zero mark lines up with the saw

blade.

Place the rip fence on the saw table so that it moves

easily in the guide extrusion. Set to required width of cut

and and hold in position by pushing down the right-hand

lock lever.

Fig. 9

Fig. 7

After installation the table needs to be aligned.

The saw blade must run throught the centre of the table

insert's slot.

Lateral alignment

● Loosen nuts holding the lower table trunnion.

● Set table by lateral movement of the lower table

trunnion as required.

● Tighten nuts, ensure table stays in the set position.

● Bolt rip fence carrier extrusion to the band saw table

with the 4 knurled screws M 6x25.

● Snap the narrow slotted table insert into the centre

table opening. The table insert with the wide slot is

only used with a tilted table for bevel cuts.

Table tilt backstop setting

● The band saw table tilts up to 45°. The table can be

tilted after loosening the wing nut on the table trunnions

● On the underside of the saw table is a backstop, which

rests on the machine frame when the table is in the 90°

position against the blade.

● Turn the backstop's hexagon head screw in or out, as

required, to set to true 90° position.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Metabo BAS 600 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,19 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Metabo BAS 600 Manual

Product: