643410
24
Zoom out
Zoom in
Previous page
1/74
Next page
A=590 mm
A1=3 mm
22
4-INSTALLATION AND ASSEMBLY
FASTENING TO THE BASE OF THE INSERT
It is mandatory to anchor the product to a support as the authorised technician can remove the combustion chamber from its seat by
means of two extendable guides while performing the annual maintenance.
Fasten the insert as follows:
measure the distance (A) from the edge of the frame to the outer edge of the support for it to be adequately set back into place.
A=590 mm (measurement from the edge of the frame to the outer edge of the support).
A1= 3 mm (measurement from the outer edge of the wall to the edge of the frame).
Remove compensation frame C (see the relative paragraph).
Loosen the lower screws (B) under the frame.
Then remove the machine and separate it from its support (D).
Set the support (D) away from the wall at the previously measured distance.
Fasten the support (D) to the base (E) or to the optional support with the screws supplied, making sure that the support anchor
surface (D) and the wall are perpendicular.
Set the machine back on the support (D), insert the screws (B) again, making sure the machine and the support are well secured in
order to guarantee product operation.
It is very important to make sure the positioning measurements of the product base have been respected and the support
anchor surface and the wall are perpendicular. Also make sure that the screws secure the machine to the support.
The product can be installed at the desired height by constructing a suitable platform. This support must be made of non-ammable
material.
The company declines all liability for any damage to objects and persons if the above-mentioned precautions are not
complied with.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MCZ Vivo 80 Pellet Hydro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MCZ Vivo 80 Pellet Hydro in the language / languages: English as an attachment in your email.

The manual is 12,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MCZ Vivo 80 Pellet Hydro

MCZ Vivo 80 Pellet Hydro Usermanual and installation guide - Dutch - 64 pages

MCZ Vivo 80 Pellet Hydro Usermanual and installation guide - French - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info