694155
34
Zoom out
Zoom in
Previous page
1/54
Next page
PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL
page 34
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
B
C
G
A
B
4.7.3.1. Room sensor
The room sensor (B) is placed behind the stove near the switch. You
are advised to extract the room sensor in a way that this comes out as
in figure (about 10 cm). In this way it does not detect the temperature
of the stove. It is advisable to do this operation during installation,
since before extracting the probe (B) it is necessary to take off the
clamp (C) that keeps it connected; operation possible by working inside
the stove thus without the sides. To extract the probe (B) it is
necessary to unscrew the protection cap (A) and slowly pull the probe
(B). After extracting the probe (B) sufficiently, close the protection cap
(A) again.
ATTENTION! Once the clamp that binds the probe
wire is taken off, avoid it coming into contact with the
hot parts of the stove.
4.7.3.2. External environment thermostat
connection
It is possible to connect the stove to an external thermostat. To make
this connection it is necessary to acquire the interface D (optional) that
is connected to the motherboard (E) of the stove on the manifold (F) as
indicated in the diagram below and in pag.53 par.7.
E
D
F
A
B
Fig.9 - Interface for the
environment thermostat
A = PROTECTION CAP
B = PROBE (FLUSH)
C = CLAMP
D = INTERFACE FOR
EXTERNAL THERMOSTAT
E = MOTHERBOARD
F = CONNECTOR FOR
INTERFACE CONNECTION
G = HOLES FOR CABLE
OUTLET
Fig. 8 - Motherboard (internal
stove)
Fig.7 - Room temperature sensor
Downloaded from www.Manualslib.com manuals search engine
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MCZ Star Air - 2009 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MCZ Star Air - 2009 in the language / languages: English as an attachment in your email.

The manual is 3,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MCZ Star Air - 2009

MCZ Star Air - 2009 Usermanual and installation guide - Dutch - 58 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info