684233

McCulloch CS 42S Manual

14
Zoom out
Zoom in
Previous page
1/536
Next page
MAINTENANCE
a WARNING: Disconnect the spark plug
before performing maintenance except for
carburettor adjustments.
We recommend all service and adjustments
not listed in this manual be performed by an
authorized or Master Service Dealer.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover items that
have been subjected to operator abuse or negligence.
To receive full value from the warranty, the operator
must maintain the unit as instructed in this manual.
Various adjustments will need to be made periodically
to properly maintain your unit.
IMPORTANT: Have all repairs other than the
recommended maintenance described in the
instruction manual performed by an authorized
service dealer.
If any dealer other than an authorized service
dealer performs work on the product, the company
may not pay for repairs under warranty. It is your
responsibility to maintain and perform general
maintenance.
MAINTENANCE SCHEDULE
Before each use
 Check fuel mixture level
 Check bar lubrication
 Check chain tension
 Check chain sharpness
 Check for damaged parts
 Check for loose caps
 Check for loose fasteners
 Check for loose parts
Every 5 hours*
 ,QVSHFWDQGFOHDQDLU¿OWHU
 Inspect and clean chain brake
 Inspect and clean guide bar
Every 25 hours*
 ,QVSHFWDQGFOHDQVSDUNDUUHVWLQJVFUHHQDQGPXIÀHU
Yearly
 Replace spark plug
 5HSODFHIXHO¿OWHU
 5HSODFHDLU¿OWHU
* Each hour of operation is approximately 2 tanks of
fuel.
MAINTENANCE PROCEDURES
CHECK FOR DAMAGED OR WORN PARTS
Contact an authorized service dealer for replacement
of damaged or worn parts.
NOTE: It is normal for a small amount of oil to
appear under the saw after engine stops. Do not
confuse this with a leaking oil tank.
 N/STOP Switch - Ensure ON/STOP switch functions
properly by pushing the switch down. Make sure
engine stops; then restart engine and continue.
 Fuel Tank - Do not use saw if fuel tank shows signs
of damage or leaks.
 Oil Tank - Do not use saw if oil tank shows signs of
damage or leaks.
CHECK FOR LOOSE FASTENERS AND
PARTS
 Bar Nuts
 Chain
 0XIÀHU
 Cylinder Shield
 Air Filter
 Handle Screws
 Vibration Mounts
 Starter Housing
 Front Hand Guard
CHECK CHAIN SHARPNESS
A sharp chain makes wood chips. A dull chain makes
a sawdust powder and cuts slowly. See CHAIN
SHARPENING.
GUIDE BAR
&RQGLWLRQVZKLFKUHTXLUHJXLGHEDUPDLQWHQDQFH
 Saw cuts to one side or at an angle.
 Saw has to be forced through the cut.
 ,QDGHTXDWHVXSSO\RIRLOWREDUFKDLQ
Check the condition of guide bar each time chain is
sharpened. A worn guide bar will damage the chain
DQGPDNHFXWWLQJGLI¿FXOW
After each use, push the ON/STOP switch down until
the engine stops, then clean all sawdust from the
guide bar and sprocket hole.
To maintain guide bar:
1. Loosen and remove bar nuts and clutch cover.
Remove bar and chain from saw.
2. &OHDQWKHRLOKROHV$DQGEDUJURRYH%
3. Burring of guide bar rails is a normal process of rail
ZHDU5HPRYHWKHVHEXUUVZLWKDÀDW¿OH
4. :KHQUDLOWRSLVXQHYHQXVHDÀDW¿OHWRUHVWRUH
VTXDUHHGJHVDQGVLGHV
Replace guide bar when the groove is worn, the guide
14
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for McCulloch CS 42S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of McCulloch CS 42S in the language / languages: All languages as an attachment in your email.

The manual is 20,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info