17
beep alarm tone will be heard if the code is
correct.
3.
The CBT function ends if it exceeds 45 seconds.
It will then enter ICM recording in “ANSWER
& RECORD” mode, or ends on-line operation
in “
ANSWER ONLY” mode or in “SYSTEM
STANDBY” mode.
4. The corresponding touch tone commands are
as follows:
End CBT functions press ”#”.
The CBT code is initially preset to ”267”. You
can change the code to any 3 digits from 000 to
999. The procedure of CBT code setup / display
is as follows:
1. Press the [REPEAT ]
key
for about 2 seconds
and release to display CBT code.
The code display / setup will be high digit
first, then middle digit, and then low digit.
2.
Press the [FORWARD ] or the [REPEAT
]
key
to increase or decrease the digit.
3. Press the [ANS] key to select the correct digit.
4.
Repeat step 2 and 3 to change following digit
setup.
5. If a keypress exceeds 8 second, the setup /
display procedure will be aborted.
6. Press the [STOP ] key to quit the CBT code
setup / display.
OPERATION
CBT CODE
CHANGE
Delta 1010 GB n e u 24.10.2002 12:00 Uhr Seite 17
