778510
13
Zoom out
Zoom in
Previous page
1/22
Next page
SAFETY
OWNER’S RESPONSIBILITY
Accurate assembly and safe and effective use of the auger is the owner’s responsibility.
Read and follow all safety instructions. Carefully follow all assembly instructions.
Maintain the auger according to directions and schedule included in this operator’s manual.
Ensure that anyone who uses the auger is familiar with all controls and safety precautions.
IMPORTANT SAFETY PRECAUTIONS
Please read this section carefully and refer to page 2.
Operate the auger according to the safety instructions and recommendations outlined here and
inserted throughout the text. Anyone who uses this auger must read the instructions and be familiar
with the controls.
The above symbols point out important safety instructions which if not followed could endanger
your personal safety. Read and follow all instructions in this manual before attempting to operate
this equipment.
Do not carry the planting earth auger between holes with the engine running.
Always keep hands, feet, hair and loose clothing away from any moving parts on engine and
auger.
Always wear a protective hearing device.
Do not allow children to operate this planting earth auger. Do not allow adults to operate the
auger without proper instruction.
Do not operate any power equipment under the inuence of alcohol or drugs.
Keep all screws, nuts and bolts tight.
Engine should be turned off and cool, spark plug wire must be removed from spark plug before
any repairs are attempted.
Temperature of mufer and nearby areas may exceed 150° F (65° C). Avoid these areas.
Never run engine indoors or in an enclosed area. Engine exhaust contains carbon monoxide, an
odorless and deadly gas.
If the planting earth auger will not turn in a hole, turn engine off and allow to cool before attemp-
ting to remove it manually.
To change or replace auger, please go to the maintenance center to change with the same size
as stated in the manual.
STARTING AND STOPPING ENGINE
Move choke lever to RUN position.
Prime unit until primer hose is lled with gas.
Move choke lever to CHOKE position.
Push rocker switch to the ON position.
Squeeze the back of trigger assembly control with right hand. Grasp starter handle with left hand
and pull out slowly, until it pulls slightly harder. Without letting starter handle retract, pull rope with a
rapid full arm stroke. Let it return to its original position very slowly until unit res or runs. Repeat this
step every time the starter rope is pulled.
After engine starts running, move choke lever to HALF CHOKE position until unit runs smoothly.
Move choke lever to RUN position and move throttle to desired speed.
To stop engine, push rocker switch to OFF position.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Maxxtools 20570 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Maxxtools 20570 in the language / languages: English, Dutch as an attachment in your email.

The manual is 2.19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info