169742
12
Zoom out
Zoom in
Previous page
1/31
Next page
12 Server Description
13MAXDATA PLATINUM 220 Server
Video
The server board S875WP1-E contains two separate, mutually exclusive graphics subsystems. You
can use either the AGP connector or the ATI Rage XL video controller. When an AGP card is installed,
the integrated 8 MB video controller is disabled.
AGP Connector
AGP is a high-performance interface for graphics-intensive applications. AGP is independent of the
PCI bus and is intended for exclusive use with graphical display devices. The AGP bus follows the
AGP 3.0 specification.
The AGP connector on the server board S875WP1-E supports the following:
2X, 4X, or 8X AGP protocol.
1.5 V add-in cards only.
Maximum bus bandwidth of 2.13 GB/sec
NOTE
The AGP connector is keyed for 1.5V AGP cards only. Do not attempt to install a legacy 3.3V AGP
card. The AGP connector is not mechanically compatible with legacy 3.3 V AGP cards.
ATI Rage XL Video Controller
The S875WP1-E server board provides an ATI Rage XL PCI graphics accelerator, along with 8 MB
of video SDRAM and support circuitry for an embedded SVGA video subsystem. The ATI Rage XL
chip contains a SVGA video controller, clock generator, 2D and 3D engine, and RAMDAC in a 272-pin
PBGA. One 2Mx32 SDRAM chip provides 8 MB of video memory.
The SVGA subsystem supports a variety of modes, up to 1600 x 1200 resolution in 8/16/24/32 bpp
modes under 2D, and up to 1024 x 768 resolution in 8/16/24/32 bpp modes under 3D. It also supports
both CRT and LCD monitors up to 100 Hz vertical refresh rate.
The server board S875WP1-E provides a standard 15-pin VGA connector and supports disabling of
the on-board video through the BIOS Setup menu or when a plug-in video card is installed in the AGP
slot or any of the PCI slots.
Video Modes
The Rage XL chip supports all standard IBM VGA modes. The following table shows the 2D/3D modes
supported for both CRT and LCD. The table specifies the minimum memory requirement for various
display resolution, refresh rates, and color depths.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Maxdata platinum 220 select at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Maxdata platinum 220 select in the language / languages: English as an attachment in your email.

The manual is 0,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info