598440
14
Zoom out
Zoom in
Previous page
1/28
Next page
14
Refueling the brushcutter
When refueling the brushcutter, please note the following in-
formation at all times!
No smoking and no open res!
Do not refuel in closed rooms!
Fuel vapors will accumulate on the ground (risk
of explosion)!
Fuels can contain solvent-like substances. Pre-
vent contact of the eyes and skin with mineral oil
products. Wear gloves when refueling. Change
and clean your protective clothing more frequent-
ly. Do not inhale fuel vapors. Inhaling fuel vapors
can cause physical damage to your health.
Before refueling the brushcutter, turn off and
allow the engine to cool down.
Operating materials/fuels
The handling of operating materials/fuels requires cautious,
careful action. Refuel the brushcutter only outdoors or in well-
ventilated rooms.
Mineral oil products, including oils, de-
grease the skin. In case of repeated, longer
contact, the skin will dry up. This can re-
sult in various skin diseases. Beyond that,
allergic reactions are well known.
Contact of the eyes with oil results in irritations.
In case of eye contact, wash the affected eye
immediately with clear water. If the irritation
does not subside, a physician must be consulted
immediately!
Gasoline
The engine of the brushcutter is designed to be run with regular
gasoline with a minimum octane number of 91 RON. If that type
of fuel is not available, fuel with a higher octane number can
also be lled into the tank without damaging the engine.
Engine oil
The engine is lubricated exclusively by the engine oil (multigrade
oil of the classication SAE 10W-30). This is why you must check
the engine oil level at a clean location before beginning to work
with the brushcutter. During this inspection, it is important to make
sure that no dirt gets onto the dipstick or into the crankcase in
order to guarantee long service life of the engine.
If, despite all precautions, dirt does get into
crankcase, the engine oil must be changed before
the engine is started.
Refueling and lling up with engine oil
The tool you will require is a clean rag.
1 Clean the area around the tank cap (
1) thoroughly, so that
no dirt can get into the fuel tank (not necessary upon rst-
time operation of the brushcutter).
2 Lay down the brushcutter, so that it is resting on its foot in
stable position.
3 Unscrew the tank cap and ll gasoline
carefully up to the
bottom edge of the ller neck.
However, if you do spill any fuel, clean the brush-
cutter immediately. If fuel gets onto your clothes,
change them immediately.
1
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita BCX3410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita BCX3410 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Makita BCX3410

Makita BCX3410 User Manual - German - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info