598386

Makita AC310H Manual

8
Zoom out
Zoom in
Previous page
1/240
Next page
8
MAINTENANCE
To ensure efficient operation and longer life of the air
compressor unit, a routine maintenance schedule should
be prepared and followed. The following routine
maintenance schedule is geared to a unit in a normal
working environment operating on a daily basis. If
necessary, the schedule should be modified to suit the
conditions under which your compressor is used. The
modifications will depend upon the hours of operation and
the working environment. Compressor units in an
extremely dirty and/or hostile environment will require a
greater frequency of all maintenance checks.
ROUTINE MAINTENANCE SCHEDULE
1. Drain water from the air tank, any moisture separators
or air filter regulators.
2. Check for any unusual noise and/or vibration.
3. Manually check all safety valves to make sure they are
operating properly.
WARNING: Risk of bursting.
Check Safety Valve. If safety valve does not operate
properly over pressurization of the air tank may result
in rupture or explosion causing personal injury and
property damage.
4. Inspect air filter, replace if necessary.
5. Inspect air lines and fittings for leaks; correct as
necessary.
Each year of operation or if a problem is suspected:
• Check condition of air compressor pump intake and
exhaust valves.
• Check condition of check valve. Replace if
damaged or worn out.
6. Keep all screws, bolts, and covers properly tightened.
Check their conditions periodically.
WARNING:
Keep All Screws, Bolts and Covers Properly
Tightened. If screws, plates or covers become loose
personal injury or property damage may occur.
1) TROUBLE SHOOTING
2) WARNING!
Wrong way to transport and lift will lead machine damaged.
Daily maintenance
1. Before each use:
A Be sure all nuts and bolts are tight.
B Check for unusual noise or vibration.
2. After each use:
Exhaust all the air in the air storage tank. Open the
drain cock at the bottom of the air storage tank to drain
condensation from tank.
3. Weekly maintenance:
A Check performance of safety valve.
B Check the air switch the designed rated pressure
is 2.8 Mpa.
C Clean the air filter.
4. Monthly maintenance:
A Inspect air system for leaks by applying soapy
water to all joints. Tighten those joints if leakage is
observed.
B Check that all nuts and bolts stay tight.
C Replace the air filter with a new one.
D Clean surface of air compressor.
5. Quarterly maintenance:
A Check the cylinder and piston see to if wore.
WARNING:
Never use the air compressor which is operating
abnormally.
If the air compressor appears to be operating
unusually, making strange noises or vibration,
stop using it immediately and arrange for repairs
by a Makita authorized service center.
WARNING:
Use only genuine Makita replacement parts.
Replacement parts not manufactured by Makita
may void your warranty and can lead to
malfunction and result in injuries. Genuine Makita
parts are available from an authorized dealer.
WARNING:
UNIT CYCLES AUTOMATICALLY WHEN
POWER IS ON. WHEN DOING MAINTENANCE,
YOU MAY BE EXPOSED TO VOLTAGE SOURCES,
COMPRESSED AIR OR MOVING PARTS.
PERSONAL INJURIES CAN OCCUR. BEFORE
PERFORMING ANY MAINTENANCE OR REPAIR,
UNPLUG THE COMPRESSOR AND BLEED OFF
ALL AIR PRESSURE.
PROBLEM CAUSE CORRECTION
Will not start Fuse blown or circuit breaker tripped;
Loose electrical connections;
Extension cord not correct;
Overheated motor
Check for cause and replace or reset; Check
wiring connections Max.15m/50ft., min.
14ga; Use reset button/wait for automatic
reset
Low pressure Air leak in safety valve
Restricted air filter
Defective check valve
Check valve manually: pull up ward on rings.
If condition persists, replace valve; Clean or
replace air filter; Replace check valve.
Safety valve releasing Defective pressure switch or improper
adjustment
Check for proper adjustment and if problem
persists, replace pressure switch
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita AC310H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita AC310H in the language / languages: All languages as an attachment in your email.

The manual is 5,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info