782325
40
Zoom out
Zoom in
Previous page
1/60
Next page
Neither operation can be performed safely freehand: rip cutting requires the use
of the rip fence, and crosscutting requires the use of the mitre gauge. Never use
the rip fence and the mitre gauge at the same time during the cutting operation.
Rip cutting
> Remove the mitre gauge, and secure the rip fence to the table.
> Raise the blade until it is approximately 1/8" (3.2 mm) above the top of the work
piece.
> Place the work piece flat on the table and against the fence so that the larger
portion of the work piece is between the blade and the fence. Keep the work
piece approximately 1" (2.5 cm) away from the blade.
> Turn the saw ON, and wait for the blade to reach full speed. Do not stand directly
in line with the saw blade’s path. Instead, stand on the side where the cut is
being made.
> Slowly feed the work piece into the blade by pushing forward on the section of
40
Product functions
MSTS1500-A by MacAllister
In more detail…
EN
Warning: Risk of injury!
If the distance between the rip fence and saw blade is less than
12 cm, the push stick [25] must be used.
Warning: Risk of injury!
Always hold the guided work piece fast, never the free work piece
which has been cut off.
Warning: Product damage!
Check the wood to be worked carefully. The device can be
damaged severely by foreign bodies such as nails, screws, etc.
Warning: Product damage!
Always use sharp saw blades. Blunt blades can overload
and damage the product.
Warning: Product damage!
Check the voltage before plug in. The voltage must comply with
the information on the rating label!.
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mac Allister MSTS1500-A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mac Allister MSTS1500-A in the language / languages: English as an attachment in your email.

The manual is 4.82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info