782325
39
Zoom out
Zoom in
Previous page
1/60
Next page
Fig. 14
65
For safety reasons, verify that the operator has read the section entitled general
safety guidelines for the table saw before operating this saw. Verify the following
before every time the table saw is used:
> The blade is tight and can run freely.
> The blade bevel locking handle is locked.
> If rip cutting, the rip fence locking handle is tight, and the fence is parallel to the
mitre gauge groove and the blade.
> If cross cutting, the mitre gauge locking handle is tight.
> The blade guard and riving knife are in place, and are working properly.
> The dust extraction hose is fixed in the slot of the hose hold.
> Safety glasses are worn.
Failure to adhere to these safety rules will greatly increase the chances of injury.
Before using the table saw, polish the tabletop with an automotive polishing wax
in order to keep it clean, and to make it easier to slide the work piece.
There are two basic types of table saw cuts: rip cutting and cross cutting. Rip cutting
refers to cutting along the length of the grain and the work piece. Cross cutting
refers to either cutting across the width or across the grain of the work piece. This
distinction may be hard to make with man made materials. Therefore, cutting a
piece of material to a different width is rip cutting, and cutting across the
short dimension is cross cutting.
66
BASIC TABLE SAW OPERATIONS
In more detail…
In more detail…
Product functions
MSTS1500-A by MacAllister
39
EN
Warning: Risk of injury!
Do not push the parallel profile [66] too far in the direction of the
saw blade. The distance between the parallel profile and the front
of the saw blade should be approx. 2.5 cm.
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mac Allister MSTS1500-A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mac Allister MSTS1500-A in the language / languages: English as an attachment in your email.

The manual is 4.82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info