782323
33
Zoom out
Zoom in
Previous page
1/42
Next page
33
MSPS1200 by MACAllister Cleaning and maintenance
Cleaning and maintenance
Ensure that the tool is switched off and the plug is removed from the power point
before making any adjustments or carrying out maintenance procedures.
Cleaning
Keep the tool’s air vents unclogged and clean at all times.
Remove dust and dirt regularly with a cloth or soft brush.
Never use caustic agents to clean plastic parts. A damp cloth is recommended.
Water must never come into contact with the saw.
Re-lubricate all moving parts at regular intervals.
Blade maintenance
Regularly check that the blade is free from a build up of gum resins or sawdust.
If necessary clean with an appropriate cleaning agent or multi-use lubricant
spray.
Regularly check the saw blade for flatness. Use of the saw with a buckled blade
places excessive load on the motor and gearbox assembly, and may affect your
warranty rights.
Check the tungsten carbide teeth regularly for sharpness and breakages;
re-sharpen or replace the blade as required. Note that when re-sharpening, the
bevel angles on the front of the teeth should be retained.
Replacing the saw blade
Only use Ø165x20mm blades with a kerf between 2.2 & 3.5mm, designed for
circular saws with a no-load speed rating of at least 6000/min.
Never fit high speed steel blades or abrasive discs. Fitting of other purpose or
different sized blades will void the warranty.
Do not fit inferior blades. Regularly check the blade is flat, sharp and free of
cracks or defects.
1. Loosen the front and rear bevel lock knobs (4 and 12) and swivel the plunge
saw to 0° position before changing the saw blade. Tighten both bevel lock
knobs again.
In more detail...
WARNING : Before any maintenance work always switch off the
plunge saw and disconnect from mains power.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mac Allister MSPS1200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mac Allister MSPS1200 in the language / languages: English as an attachment in your email.

The manual is 3.56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info