587003
16
Zoom out
Zoom in
Previous page
1/32
Next page
Page 13
7.2.3 Switching and verifying mode
Switching between 16-channel and 32-channel mode is done by holding down the TO ANALOG
OUT button on the Aurora front panel for one-half second. All of the Aurora LEDs will flash to
confirm the switch has occurred. There are two ways to confirm that a unit is in 16-channel or
32-channel mode:
1.
Run the Aurora Remote Control software via MIDI. The Aurora Remote Control
software is available for OSX or Windows computers, and is on the Lynx Installation
disk, or it can be downloaded from www.lynxstudio.com
> Support > Downloads. On the
Analog I/O page, the LSLOT CHANNEL MODE label will display either “32-channel”
or “16-channel”.
For more information about the Aurora Remote Control software, see Aurora Remote
Control Software.
2.
The Aurora channel state can be determined by putting the Aurora into “demo mode”.
This is done by pressing down the TRIM and POWER buttons at the same time with the
power to the Aurora off. This will cause the Aurora LEDs to flash sequentially from left
to right. In addition to this, if the three LEDs around the TO ANALOG OUT button flash
together repeatedly, then the Aurora is in 32-channel mode. If they do not, then it is in
16-channel mode.
7.2.4 What about an Aurora 8?
There is no equivalent mode option for an Aurora 8. An Aurora 8 will always operate in 16
channel mode, where the analog and digital inputs and outputs are independent.
With an Aurora 8, the LT-MADI extracts 16 audio channels from the MADI inputs and routes
channels 1-8 to the Analog Outputs, and channels 9-16 to the AES outputs. Similarly, the signals
from the Analog inputs are routed to MADI outputs 1-8, signals from the AES Inputs are routed
to MADI outputs 9-16.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lynx LT-Madi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lynx LT-Madi in the language / languages: English as an attachment in your email.

The manual is 2,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info