599449
9
Zoom out
Zoom in
Previous page
1/16
Next page
| 9
StructureScan HD | Installation
Jackplate Mount
The StructureScan transducer can be mounted inside or outside of
the jackplate by drilling through the jackplate and then running bolts
though the hinge hole in the side of the bracket into the jackplate.
Jackplate Mount Supplies (not included)
M6 or 1/4” Drill bit (Jackplate
Mount) pilot holes
1/4” (M6) jackplate mount bolts
To Mount StructureScan on Jackplate:
1. Choose a transducer location on the inside or outside of the jackplate.
2. Adjust the jackplate up and down to make sure the transducer will not ob-
struct jackplate movement.
3. Make sure nothing blocks the sonar beam on either side of the transducer.
4. Route the transducer cable to the location where the module will be
installed.
5. Move the transducer bracket into the desired position and use a pencil to
mark the holes through the hinge hole and hole in the side of the bracket.
6. Using a M6 or equivalent drill bit, drill the holes into the jackplate.
7. Slide the bracket inside the jackplate and align the bracket holes with holes
you drilled in the jackplate.
8. Slide M6 bolts with washers into each hole on the side of jackplate.
9. Guide the bolts through the StructureScan bracket holes.
10. Place a washer over the end of the bolts and tighten the nuts.
11. Connect the transducer cable to the StructureScan module sonar port.
StructureScan bracket mounted
inside the jackplate. The bracket can
also be installed on the outside of
the jackplate.
Jackplate
Warning: Before installing the StructureScan HD transducer
on the jackplate, lower the jackplate to its lowest setting to make
sure there is enough clearance between the jack plate/engine
and the transducer. Lack of clearance could damage the trans-
ducer when the engine is all the way down.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance STRUCTURESCAN-HD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance STRUCTURESCAN-HD in the language / languages: English as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance STRUCTURESCAN-HD

Lowrance STRUCTURESCAN-HD User Manual - English - 28 pages

Lowrance STRUCTURESCAN-HD User Manual - German - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info