522456

Lofrans Falkon Manual

12
Zoom out
Zoom in
Previous page
1/55
Next page
Verricello Salpa Ancora mod. Atlas / Cayman 88 / Tigres / Falkon
11
4 IMPIANTO ELETTRICO 4 ELECTRICAL SYSTEM 4 SECTION CABLES ELETRIQUES 4 ELEKTRISCHE ANLAGE 4 SISTEMA ELECTRICO
Model
Motor
Power
(W)
Voltage
(V)
Contactor (A)
Cable sizing according lengh of cable (positive + negative)
15-25 m 50-75 ft > 25 m > 75 ft
Atlas/Cayman 88 600/700
12 70 25 mm2 3 AWG - -
Cayman 88 700 24 35 16 mm2 4 AWG - -
Cayman 88 1000 12 100 35 mm2 2 AWG 50 mm2 2 AWG
Cayman 88 1000 24 70 25 mm2 3 AWG 35 mm2 3 AWG
Tigres 1500 12 100 50 mm2 2 AWG 75 mm2 000 AWG
Tigres 1500 24 70 35 mm2 3 AWG 50 mm2 2 AWG
Falkon 1700 12 125 50 mm2 2 AWG 75 mm2 000 AWG
Falkon 1700 24 70 35 mm2 3 AWG 50 mm2 2 AWG
4.1 Sezione dei cavi elettrici
E’ essenziale che il salpa ancora sia
cablato con cavi di sufficiente sezione
come suggerito in tabella.
4.2 Solenoidi (Control Box)
Collocare in un luogo asciutto vicino al
verricello.
4.3 Circuit breaker
I circuit breaker consigliati da Lofrans
hanno una curva di intervento e non un
semplice valore di targa. Gli interruttori
selezionati per ogni modello
garantiscono il corretto funzionamento
del sistema.
4.4 Pannello di controllo remoto
Il pannello di controllo remoto deve
essere montato in una posizione
comoda (come ponte, timone o
pozzetto), in modo che l'operatore
possa vedere il verricello durante la
manovra. Montare e sigillare il
pannello in modo che i terminali
risultino in un luogo asciutto.
4.1 Electrical cable section
It is essential that the anchor windlass be
wired with cables of sufficient section as
suggested in the table.
4.2 Solenoid valves (Control Box)
Place it in a dry place near the capstan.
4.3 Circuit breakers
The circuit breakers recommended by
Lofrans have an intervention curve and
not a simple plate value. The switches
selected for each model guarantee the
correct operation of the system.
4.4 Remote control electric panel board
The remote control electric panel board
must be mounted in a comfortable
position (such as the deck, the rudder or
the cockpit), so that the operator can see
the capstan during the manoeuvre.
Mount and seal the electric panel board
so that the terminals remain in a dry
place.
4.1 Section des câbles électriques
Est essentiel que le guindeau soit
câblé avec des câbles d’une section
suffisante, comme montré dans le
tableau.
4.2 Solénoïdes (Control Box)
Placer dans un endroit sec, près du
treuil.
4.3 Disjoncteur
Les disjoncteurs conseillés par
Lofrans ont une courbe d’intervention
et pas une simple valeur d’étiquette.
Les interrupteurs sélectionnés pour
chaque modèle garantissent le bon
fonctionnement du système.
4.4 Panneau de commande à
distance
Le panneau de commande à distance
doit être monté dans un endroit
pratique (le pont, le gouvernail ou le
cockpit), de façon à ce que l’opérateur
puisse voir le treuil durant la
manœuvre. Monter et sceller le
panneau de sorte que les extrémités
des câbles se trouvent en lieu sec.
4.1 Querschnitt der Stromkabel
Ist es von grundlegender Bedeutung,
dass die Ankerwinde mit Kabeln mit
ausreichendem Querschnitt (siehe
Angaben in der Tabelle) verkabelt wird.
4.2 Relaisbox (Control-Box)
An einem trockenen Ort in der Nähe der
Ankerwinde anbringen.
4.3 Sicherungsautomat
Die vom Unternehmen Lofrans
empfohlenen Sicherungsautomaten
haben eine Auslösekurve und keinen
einfachen Typenschild-Wert. Die für
jedes Modell ausgewählten Schalter
garantieren den richtigen Betrieb der
Anlage.
4.4 Fernbedienungs-Schalttafel
D
ie Fernbedienungs-Schalttafel muss
einer bequemen Position (wie Brücke,
Ruder oder Cockpit) montiert werden, so
dass der Bediener die Ankerwinde
während des Manövers sehen kann. Die
Fernbedienungs-Schalttafel so montieren
und abdichten, dass sich die Anschlüsse
an einem trockenen Ort befinden.
4.1 Sección de los cables eléctricos
E
s esencial que el molinete esté cableado
con cables de sección suficiente, como se
sugiere en la tabla.
4.2 Solenoides (Control Box)
Coloque en un lugar seco cerca del
cabestrante.
4.3 Circuit breaker
Los "circuit breaker" aconsejados por
Lofrans tienen una curva de
intervención, en vez de un simple valor
nominal. Los interruptores seleccionados
para cada modelo aseguran el
funcionamiento correcto del sistema.
4.4 Panel de mandos a distancia
El panel de mandos a distancia se debe
montar en una posición cómoda (como el
puente, el timón o el pozo), para que el
operador pueda ver el cabestrante
durante la maniobra. Monte y selle el
panel de modo que los bornes estén en
un lugar seco.
www.busse-yachtshop.de | info@busse-yachtshop.de
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lofrans Falkon at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lofrans Falkon in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 2,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info