Manual LivarnoLux IAN 113911 (page 7 of 61) (English, German, Dutch, Danish, French, Swedish, Finnish)

649223

Zoom out

Zoom in

1/61

7 GB/IE

Introduction / SafetyIntroduction

Bluetooth range: approx. 10 m

Control method

Remote control: infrared

Remote control range: < 8 m

Safety

Safety instructions

Damage due to failure to comply with these instruc-

tions for use will void the warranty! We assume no

liability for consequential damages! We assume no

liability for property damage or personal injury due

to improper handling or failure to comply with the

safety instructions! Do not leave the lamp or packag-

ing material lying unattended. Plastic ﬁlm or bags,

plastic parts, etc. can be dangerous for children to

play with.

Avoid the risk of fatal injury

from electric shock

Have the electrical installation performed by

an electrician or a person trained in electrical

installation.

Always check the mains supply for damage be-

fore connecting it to the mains. Never use the

light if it shows any signs of damage.

CAUTION! A damaged mains cable poses a

danger to life due to electric shock. In the event

of damage, repairs or other problems with the

light please contact the service centre or an

electrician.

Prior to installation, remove the fuse or switch oﬀ

the circuit breaker (0 setting) in the fuse box.

Prior to installation, verify the mains voltage on

site corresponds with the operating voltage re-

quired for the light (220–240 V∼, 50 / 60 Hz).

Never allow the light to come into contact with

water or other liquids.

Never open the housing of the light or insert

any objects into it. This will pose a risk of fatal

injury from electric shock.

The LED module is not replaceable. If the LED

module fails at the end of its life, the entire light

must be replaced.

Do not install the light on a wet or conductive

surface!

Prevent fire and risks

of injury

Do not leave the light or packaging lie about

carelessly. Plastic ﬁlm or bags, plastic parts,

etc. are dangerous for children to play with.

Do not cover the lamp with objects. Excessive

heat can result in ﬁre.

Safe working

Mount the light so it is protected from moisture

and dirt.

Carefully prepare for assembly and allow your-

self adequate time. First organise all parts or

materials so they are easy to reach.

Always be attentive! Always pay attention to

what you are doing and proceed with caution

at all times.

Never assemble the lamp whilst unfocused or

feeling unwell.

Safety Instructions for batteries

Never expose batteries to excessive heat such

as sun, ﬁre, etc. The batteries may explode!

Never recharge non-rechargeable batteries.

Explosion hazard!

Keep batteries away from children, do not

short-circuit or take apart.

Replace all batteries in a set. Only use the same

types of batteries together, never mix types or

used and new batteries.

Clean battery contacts and the contacts inside

the device before inserting the batteries.

Be sure to insert the batteries correctly, i.e. note

the polarity (+ and –).

Remove drained batteries immediately.

creased risk of leaks!

After 3 years of use the lamp has started blinking when switched on. The installation is fine, coul it be the transformer. Is it possible to replace it? Submitted on 27-4-2020 at 19:19
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of LivarnoLux IAN 113911 in the language / languages: English, German, Dutch, Danish, French, Swedish, Finnish as an attachment in your email.

The manual is 0,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

LivarnoLux IAN 113911 Manual

Product: