727826
27
Zoom out
Zoom in
Previous page
1/77
Next page
23
Setup
Linksys
Dynamic Routing
Enter the settings for dynamic routing by using Routing Information Protocol
(RIP)
Dynamic Routing for IPv4:
Working Mode: Select the working mode of the device:
Gateway mode or Router mode.
RIP: Click “Enabled” to enable the RIP function.
Receive RIP versions: Select one of “None, RIPv1, RIPv2,Both RIP v1
and v2”.
Transmit RIP versions: Select one of“None,RIPv1,RIPv2-
Broadcast,RIPv2-Multicast”.
Dynamic Routing for IPv6
NOTE: You should enable Dual-Stack IP to configure dynamic routing for IPv6.
RIPng: Click “Enabled” to open the function.
Static Routing
When there are more than one router and IP subnets, the routing mode for
the device should be configured as static routing. Static routing enables
different network nodes to seek necessary paths automatically. It also enables
different network nodes to access each other.
Destination IP: Input the remote network IP address
that is to be routed. For example, the IP/
subnet is 192.168.2.0.
Subnet Mask (IPv4 only): Input the remote network subnet
that is to be routed. For example,
255.255.255.0.
Prefix Length (Pv6 only): Input the prefix length.
Default Gateway: The default gateway location of the
network node that is to be routed.
Hop Count (Metric, max. is 15): This is the router layer count for the IP. If
there are two routers under the device,
users should input “2” for the router
layer. The default is “1. (Max. is 15.)
Interface: Select WAN port or LAN port for
network connection location.
Select LAN if this router gets Internet
connectivity from a gateway router on
your LAN.
Add to List: Add the routing rule into the list. You
can enter up to 30 routes.
Delete: Remove the selected routing rule from
the list.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Linksys LRT224 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Linksys LRT224 in the language / languages: English as an attachment in your email.

The manual is 4,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info