654230

Lelit Diana PL60 PlusTR1 Manual

7
Zoom out
Zoom in
Previous page
1/20
Next page
7
English
22. Press the toggle steam switch (9) up paying attention that the steamer always stays immerse in the liquid, to avoid
possible hot drink sprays.
23. Press the toggle steam switch (9) down to stop steaming and remove the steam tube (10) from the cup/mug.
24. The steam tube (10) can become extremely hot so make sure to handle it only touching the rubber safety protection.
25. Clean the steam tube (10) accordingly with a normal damp cloth.
Hot water:
26. Check that the tank contains water. ATTENTION: the internal tank has a special floating device that controls the water
level. In case of lack of water, the water missing pilot light (17) comes on automatically and at the same time the sound
allarm buzzes. Please fill the water tank with water (as described under Starting the machine, points 3-5): this will shut
off the pilot light (17) and the buzzer, confirming that the water level is suitable. NB: the water tank must be filled in
with water till the MAX level indicated on the appliance body.
27. Wait till the PID’s (16) display shows the set temperature and the coffee ready pilot light (4) goes off.
28. Place a mug under the hot water faucet (11) and press the hot water switch (20) up: the pilot light (21) confirms the
starting. Once you get the desired amount of hot water press the switch (20) down to stop dispensing.
29. After having taken hot water, always check that there is still water in the tank and if it is necessary, fill the water tank
with water.
HOW TO SET THE BOILER’S TEMPERATURE BY MEANS OF THE PID:
The PID has been set by the producer of this machine on a temperature of 95°C. In order to change the temperature
please proceed as follows:
4. press the button ; as soon as the display shows the writing “PRG” press the button ;
5. as soon as the display shows the boiler’s temperature, help yourself with the buttons and in
order to set the desired temperature, starting from a min. of 80C° up to a max. of 130C°.
6. after 3 sec. from pressing the last button, the inserted temperature is memorized and the display shows the set
temperature.
NB: if the temperature is set too high, once a coffee request is made, the display starts to flash.
ROUTINE MAINTENANCE AND PRECAUTIONS:
− Clean up the steam tube (10) after every use.
− Use a normal damp cloth to clean the machine.
− Do not leave the machine outdoors.
− Do not immerse the machine in water.
− Use the machine only under adult control and keep it away from children’s reach.
− Do not wash filters and filter holder in the dishwasher.
− During normal functioning some parts of the appliance body can reach high temperatures: please handle with due
caution!
− The PID is already set by the producer on the right temperature for an excellent espresso. During heating and
coffee or water distribution, the temperature can oscillate (+/- 10/12°C). A warning has been also inserted:
after 113°C the PID’s display shows the temperature but intermittently; this is normal: it warns the user that
the coffee will not be good if made with such high temperature.
ATTENTION: the machine is equipped with a water tank of 2.7l with missing water sensor connected to an allarm pilot light
(17) and also to a buzzer. The sound of the buzzer caused by the lack of water at starting the machine is different from the
sound made to indicate the lack of water during normal funtioning. The restoration of the suitable water level will shut off
the allarm pilot light (17) and the buzzer. If the water finishes during the normal funtioning the missing water sensor will
allow 15sec. of time to finish the coffee; once the coffee is done the water tank must be filled with water till the max level
indicated on the appliance body.
We suggest reading the instruction booklet carefully and checking the water level in the water tank regularly.
Water softener included (inserted on the plastic tube, inside the water tank): one way water softener for espresso
machines. It protects the machine from limestone residues. It needs to be replaced according to the water hardness and
consumption following the below table:
Water hardness
Quantity
10°F 90 lt
20°F 45 lt
27°F 35 lt
35°F 23 lt
45°F 20 lt
NB: It’s is necessary to replace the resin filter as indicated above otherwise the limestone residues can damage the coffee
machine (the warranty does not cover this type of damage).
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lelit Diana PL60 PlusTR1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lelit Diana PL60 PlusTR1 in the language / languages: English, German, Italian as an attachment in your email.

The manual is 1,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info