Manual Leen Bakker 52401058 Patton (page 28 of 45) (English, German, Dutch, French)

821319

Zoom out

Zoom in

1/45

GB, IE

• To reduce the risk of under cooked meat cut open to ensure it is cooked all the way through internally.

• CAUTION–ifthemeathasbeencookedsufcientlythemeatjuicesshouldbeclearandthereshouldbeno

traces of pink/red juice or meat colouring.

• Pre-cookinglargerpiecesofmeatandjointsisrecommendedbeforenallycookingonyourgrill.

• After cooking on your Kamado always clean the grill cooking surfaces and utensils.

REFUELING

• With the vents closed, the Kamado stay at a high temperature for several hours. If you require a longer

cooking time (e.g when roasting a whole joint or slow smoking), it may be necessary to add more charcoal.

Just add some additional charcoal and continue as above.

REPLACING THE FELT PACKING ON THE KAMADO GRILL

Depending on how you use the Kamado Grill, the felt packing around the lid and the base should be replaced from time to

time. This prevents “false air” from occurring. Carefully carry out the following:

Requirements:

- self adhesive felt packing

- open-ended spanner

- scraper and/or Stanley Knife

- pot scourer of abrasive pad

- acetone

- masking tape

1. Remove the adjustable cut-off or ceramic lid cap. Unscrew the nuts on the top tensioning band with the

 spanner,thennext,carefullyliftoffthelidandlayitupsidedownontoaprotectivelayerontheoor.

Make sure that you do not drop the lid!

2. Unscrew the bottom tensioning band and leave the ceramic base standing in the housing or on the table.

3. Using the Stanley Knife or scraper, cut or scrape off as much of the existing felt packing as possible.

Remove the remaining bits of felt and glue with the acetone an the action of an abrasive pad or pot scourer

4. Now you must wait for about one hour until the acetone has evaporated.

5. Carefully stick the new (self adhesive) felt packing to the edge of the base and the lid. Make sure that the

seams are not at exactly the same place again and allow the felt to overlap slightly on the outside, which is

better than on the inside (because it will burn when the grill is lit once again). Allow a little play when sticking

down the felt packing (therefore not too tight or stretched), so when warming up the felt packing is able to

shrink a little. Neatly cut the felt packing at the seam. It you are using adhesive in place of self adhesive tape,

please do as follows:

Apply the masking tape immediately under the edge of the base and the outside of the lid so that the adhesive

does not stick to the Kamado Grill itself. Protect the inside of the grill with a piece of cardboard and then spray

the edges with the adhesive. Follow the instruction for the adhesive and allow it to dry and then stick the felt

packing onto the edges. Allow the glue to completely harden.

6. Reassemble the Kamado Grill. Place the tensioning band against the base and tighten the nuts. Carefully put

the lid into the top tensioning band and tighten the nuts. Check whether the lid and the tensioning bands are

 straightandthengivethenutsanaltighten.

TERMS & CONDITIONS OF THE LIMITED GUARANTEE FOR THE PATTON KAMADO GRILL

Every Patton Kamado Grill ceramic cooker has a limited guarantee covering the materials and construction of all tyhe

ceramiccomponents(e.g.canopy,frame,uwithcut-off,rebasketandinnerring).Thisguaranteeiseffectiveforaslong

as the original purchaser remains in possession of the Patton Kamado Grill or the covered component.

The Patton Kamado Grill has a limited manufacturer’s guarantee of 2 years for the original purchaser. The ceramic

components are not covered for breakages caused by dropping or misuse. The components made from metal, stainless

steel or cast iron on the Patton Kamado Grill (e.g. metal bands, hinging mechanism, metal covers with double function,

grill,rebasketandregulatingslide)havealimitedmanufacturer’sguaranteeof1yearfortheoriginalpurchaser.

Patton endeavours to use only rustproof materials and paint that can resist high temperatures and is used on the metal

surfaces.However,metalmaterialsandprotectivenishingcoatscanbeaffectedbysurfacecrackingorexposureto

various substances and circumstances over which Patton has no control.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Leen Bakker 52401058 Patton in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4.61 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Leen Bakker 52401058 Patton Manual

Product: