646792
21
Zoom out
Zoom in
Previous page
1/116
Next page
21
Revolution / Revolution Green
Single slope
function
Commander 50
In automatic mode, an axis can be manually set to a
certain slope using this function, even if the ADS tilt
function is also active. This means that one axis can be
re-adjusted whilst the other is aligned horizontally and/
or vertically. Press the slope/man button to activate the
function and select the X or Y axis. The slope LED lights
up, as does the LED for the X or Y axis. The slope is
re-adjusted using the plus/minus buttons. ATTENTION:
This function cannot be used to perform full horizontal
levelling, just to adjust one axis.
Manual slope
function
Commander 50
This function deactivates the automatic sensor, which
enables two axes to be re-adjusted simultaneously and
steep slopes to be set. To use the function, press the
slope/man button repeatedly until the man LED lights
up. Use the tilt button to toggle between the X and Y
axes. The plus/minus buttons are used to re-adjust the
slope by means of a motor. In vertical operation, press
the slope/man button 3 times to activate the manual
slope function for the Z axis. IMPORTANT: Since the
automatic sensor is not active, horizontal and/or vertical
levelling cannot take place.
Adjustment
mode
Commander 50
This mode can be used to re-adjust the device. With the
device switched off, press and hold down the slope/man
button. Then press the ON/OFF button briefly, keeping
the slope/man button pressed down until the X, Y and
Z axis LEDs light up simultaneously. Open the cover on
the Commander 50 and use the X/Y button to select
the required axis. Now use the plus/minus buttons on
the adjustment panel to set the selected axis; see the
"Adjustment mode" section for more information. In
vertical operation, the device activates the Z axis auto-
matically. Save your new setting by pressing the enter
button.
Power
management
The device can be operated using the high-performance
rechargeable battery or standard alkaline batteries.
GB
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner Revolution at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner Revolution in the language / languages: English, German, Dutch, French, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 2,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info