577627

Laserliner AutoControl-Master ACM Manual

23
Zoom out
Zoom in
Previous page
1/58
Next page
ENGLISH 23
Calibration
Calibration is now done electronically
A. Switch on calibration mode
Calibration can now be done electronically using the remote control.
1. Switch off the tool and, with the -button depressed, switch on again (briefly
press the -button). Keep the -button depressed down until the
- LED lights up. The -button can now be released.
2. One of the three LEDs will light up to show which axis can be calibrated.
X-axis = left LED, Y-axis middle LED, Z-axis = right LED
3. Calibration can now be continued using the remote control.
To change over between the X and Y axes, press the -button.
4. To adjust the Z axis, end calibration for the X and Y axes (see D). Position the
tool vertically, switch on in calibration mode, and again perform the complete
calibration process.
B. Checking and calibration of the X/Y/Z axes
See page 22
C. Correcting the calibration
Using the and buttons of the remote control (by repeated pressing),
move the point from its present position to the level of reference point M or B2.
D. Finishing the calibration
Cancel: By switching off the tool, the calibration adjustments made so far will be
lost and the preceding condition restored.
Save: By pressing the -button, the calibration is saved.
auto
man
tilt
auto
man
auto
man
auto
man
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner AutoControl-Master ACM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner AutoControl-Master ACM in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish, Finnish as an attachment in your email.

The manual is 2,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info