719541

Lanaform LA120420 Manual

6
Zoom out
Zoom in
Previous page
1/60
Next page
6 / 60 CN-100 P
EN FR NL DE ES IT SL BG
10. Description of the
compressor’s status
Once you press the stop/start
button, the compressor starts
running and the operating light
indicator lights up. The compressor
will run for 15 minutes.
If you press the stop/start button a
second time, the compressor stops
and the light indicator goes out.
If the batteries are at, the com-
pressor stops and the light indicator
ashes for 2 minutes, indicating that
the batteries need to be changed.
If possible, choose to run the
device using the USB cable
rather than batteries.
Indicator Light
ON/OFF
ADMINISTERING THE DRUG
1. Hold the nebulisation kit
as shown on the right.
Do not tilt the nebulisation
kit at an angle of more than 45° in
any direction. The drug may run
into your mouth or nebulisation
might not be eective.
OK
2. Turn the mains switch to the
ON position (I). The compressor
switches on and nebulisation starts.
To stop nebulisation
Turn the mains switch to
the OFF position (I).
Do not cover the compressor
with any cover or towel
etc. when it is in use.
Do not block the air lter cover.
ON/OFF
3. Inhale the drug as instructed by
your doctor and/or your therapist.
a) Using the adult’s/child’s mask
Attach the mask so that it covers
your nose and mouth and inhale the
drug. Breathe out through the mask.
b) Using the mouth piece
Insert the mouth piece into
your mouth and inhale the
drug by breathing normally.
Breathe out normally
through the mouth piece.
a) b)
4. Switch o the device at the end of
treatment. Check that there is no
condensation or moisture in the
air tube and remove the batteries
or disconnect the USB cable and
the 1A minimum adapter (not
supplied) that has been used.
Some condensation may form
in the air tube. Do not put the air
tube away if the there is any con-
densation or moisture left inside
it. It might be infected by bacteria.
If there is moisture or liquid
still left in the air tube, remove
the moisture as follows.
a) Check that the air tube is still
connected to the air intake
duct on the compressor.
b) Check that the compressor is
connected to the appropriate
USB cable or that the batteries
are inserted correctly in
their compartment.
c) Disconnect the air tube from
the nebulisation kit.
d) Start the compressor and
pump the air through the air
tube to expel the moisture.
ON/OFF
DC 5V 1A
ON/OFF
DC 5V 1 A
DAILY CLEANING AND DISINFECTING ROUTINE
A. CLEANING
If you follow the cleaning instructions after each use, you will prevent the drug left behind
in the reservoir from drying, thus allowing the device to nebulise eciently as well as
preventing any contamination.
Rinse the nebulisation kit, children’s accessory, mask or mouth piece thoroughly
with hot tap water each time it is used and disinfect it after the last treatment of the day.
1 Check that the mains switch is in the OFF position ( ).
2 Disconnect the USB cable from the compressor’s connec-
tor and/or take the batteries out of their compartment.
3 Disconnect the nebulisation kit from the air tube and dismantle it.
4 Dispose of any of the drug left behind in the drug reservoir.
5 Wash all the nebulisation components with hot water and
mild detergent and rinse with hot tap water.
6 Having cleaned and disinfected the components, rinse them thor-
oughly in clean water and allow to dry in the air in a clean place.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lanaform LA120420 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lanaform LA120420 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 15,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info