20433
36
Zoom out
Zoom in
Previous page
1/143
Next page
Chapter 3 Using the Operator Panel
3-20
Display the desired baud rate and press the
ENTER
key.
Press the
MENU
key. The message display returns to
Ready.
Q
QQ
Q Changing Network Interface Parameters
This printer is equipped with the network interface.
For details on networking, refer to the “Quick Configuration
Guide”.
Press the MENU key.
Press the 3 or 4 key repeatedly until Interface >
appears. One of the interface names shown below ap-
pears, indicating the current interface.
Parallel (default)
Serial
Network
Option (only when an optional network interface
card is installed)
Press the ENTER key. A blinking question mark (?) ap-
pears.
Press the 3 or 4 key repeatedly until Network ap-
pears.
Press the
ENTER
key again.
Press the 2 key. Each time the 3 or 4 key is pressed,
the display changes as shown below.
The following example explains how to activate TCP/IP
protocol to connect the printer in the network. You can
select Netware or EtherTalk in a similar manner.
If TCP/IP is currently displays Off, select On using the
3 or 4 key. Press the ENTER key again.
Interface
?Parallel
Interface
?Network
9
10
1
2
3
4
5
>NetWare
On
>TCP/IP
On
>EtherTalk
Off
>Network Status
Page On
If turns ON, print the
standard Network Inter-
face Status Page after
the Printer Status Page.
See
page 3-10
.
>Opt. StatusPage
On
If turns ON, print the op-
tional Network Interface
Status Page after the
Printer Status Page.
See
page 3-10
.
>TCP/IP >
On
>TCP/IP
? Off
>TCP/IP >
On
6
7
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kyocera FS9500DN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kyocera FS9500DN in the language / languages: English as an attachment in your email.

The manual is 5,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info