Manual Krups f 893 (page 15 of 39) (English, German, Dutch, French, Italian, Spanish)

361252

Zoom out

Zoom in

1/39

• Avoid contact with the hot parts of the

appliance by the cord or your hands

(hotplate for cups, capsule holder, steam

nozzle).

• Never immerse the appliance in water.

• Keep out of reach of children and do not

allow the cord to hang down.

• Follow the descaling instructions.

• Do not use the machine if it has been

damaged or if the cord is in poor condition.

• If the cord or any other specific element

becomes defective, these must be replaced

only by an approved Krups service centre.

You should never under any circumstances

open the appliance yourself. See Service

Agent leaflet for details.

• Check that the capsule holder is firmly in

place before making coffee and reset the

selector to

before loosening the capsule

holder.

Accessories

For best results, the appliance is delivered with

a set of accessories:

• 2 espresso cups

• 2 varieties of Nespresso coffee (2 x 10

capsules)

• 1 special hexagonal key (for dismantling the

capsule holder)

• 1 cleaning needle

For further information on the different

varieties of coffee available, or to order

capsules, you should contact your Nespresso

Club.

Setting-up the appliance

• Press on the lid of the water tank (1).

• The handle folds automatically. Fill the tank

with water (2).

You can also remove the water tank by raising

the handle (3).

Maximum capacity

1.1 L = 18 cups of espresso.

• Replace the water tank and press down

firmly so that the lower valve opens. Close

the lid again (4).

For a good cup of coffee, it is recommended

that you observe the following points:

• Empty the water tank after use.

• Change the water daily.

• Do not use mineral water or distilled water.

• Clean the water tank at least once a week.

Before using your espresso

maker for the first time

• Plug in the appliance.

• Rinse the heating system thoroughly by

running through two tanks of fresh water

(without a capsule or capsule holder).

• Introduce the empty capsule holder into the

fixing ring: to do this, position the handle at

about 90° to the left then turn; once

positioned, the handle should be facing you

or very slightly offset to the left (5).

• Place a container, as large as possible, under

the capsule holder. The function selector

must be in position

(6).

• Engage the on/off switch.The operating

indicator light (red) and the thermostat

indicator light (yellow) will come on (7).

• Once the yellow light goes out (which

means the machine is hot), set the function

selector to position

. Allow one tank of

water to run through the empty capsule

holder (8).

Preparing an espresso

• Fill the water tank with fresh water; to

preheat the capsule holder, leave it in place

in the fixing ring (but empty, with no

capsule)

• Turn the function selector to

. Switch on

the appliance. Both indicator lights will come

on (9).

• Wait until the temperature indicator light

has gone out (yellow).

Art. 893.PM6.5 21/01/04, 11:4415

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Krups f 893 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,57 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Krups f 893 Manual

Product: