690019

Krups ET3520 Manual

9
Zoom out
Zoom in
Previous page
1/45
Next page
11
EN
If your appliance is still not running properly, please contact the customer service department for your
country.
PROBLEM SOLUTION
The coffee does not flow or the
appliance does not turn on.
■ Make sure that the appliance is properly plugged into a functioning socket,
and that 0:00 is displayed.
■ The water tank is empty.
■ There was a power failure.
■ Unplug the machine, and then plug it in again.
■ The clock time must be reset after a power failure.
■ The automatic stop function has switched the appliance to standby mode.
Press a button to activate it again. For more information, see the section
"Coffee Preparation".
The appliance appears to leak.
■ Make sure that the water tank has not been filled beyond the maximum limit.
It is taking a long time for the
coffee to start flowing through.
■ It may be time to descale the appliance.
■ Certain minerals can accumulate in the coffee maker circuit. We
recommend that users regularly descale the machine. You may need to do
it more frequently, depending on your water hardness. For more
information, see the section "Descaling".
PLEASE NOTE: do not disassemble the appliance.
The coffee is spilling from the
filter holder or the coffee is
flowing very slowly:
■ The coffee maker needs to be cleaned.
■ There is too much coffee. We recommend using a measuring spoon or a
tablespoon of ground coffee per cup.
■ The ground coffee is too fine (for example, the grind for expresso is not
suitable for a filter coffee maker).
■ Some ground coffee has become embedded between the filter paper and
the filter holder.
■ The filter paper is not open enough or is incorrectly positioned.
■ Rinse the filter holder before inserting the filter paper so that the latter
adheres to the damp sides of the filter holder.
■ Make sure that you have used the recommended size of filter paper (no. 4
or no. 6).
■ There is more than one filter paper in the filter holder.
■ Make sure that the filter holder is fully inserted.
The coffee tastes bad.
■ Clean the coffee maker.
■ The coffee grind is not suitable for your coffee maker.
■ The proportion of coffee and water is incorrect. Modify it to suit your taste.
■ The quality and freshness of the coffee are not at their best.
■ The water is of poor quality.
The coffee does not flow.
■ Make sure that there is water in the tank.
■ The coffee flow system may be blocked. You can clean it by simply rinsing
it with water.
The time is not correct (there is
a gap).
■ The timer is synchronised and depends upon your electrical network. If
there is a gap, we recommend setting the time once a month to make sure
that it is correct.
A stop during a cycle: the
machine stops when there is
still some water in the water
tank.
■ This means that your machine is scaled up.
■ It is strongly recommended to perform a monthly descaling operation on your
machine, according to your water hardness.
■ For more information, see the section "Descaling".
8. TROUBLESHOOTING
KR_CAFETIERE_ET35_EO_M9_NC00136850.qxp_Mise en page 1 18/11/2016 08:53 Page11
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups ET3520 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups ET3520 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 5,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info