508723
23
Zoom out
Zoom in
Previous page
1/31
Next page
SPEED DOME CAMERA 

Dome address setting
The control commands contain target
dome’s ID. The dome only reacts to the
command sent to its own address or
broadcast address.
Each dome should be assigned an address.
Four kinds of IDs are applicable for domes:
1. Hard ID:
Hard ID is set via DIP SW2 can not be
changed from OSD menu. Hard ID
ranges from 1 to 254.
2. Programmable ID:
Set all 8bits of SW2 to ON to activate soft
address. Input 10-bit camera SN number,
and then set dome ID by controller (The
dome SN number can be found on the
side of the camera or on the package and
user manual.).
3. Broadcast ID:
Broadcast ID is programmable.
When broadcast ID is available, all domes
connected to the control bus will react to
the command. The default broadcast ID
is 255.
SW2 is for dome ID setting. The setting is
strictly according to binary system. If you
are not familiar with binary system
please look up the address setting chart.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SEC-CAM901 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-CAM901 in the language / languages: English as an attachment in your email.

The manual is 2,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info